Charging and Installing the Battery
Read and understand the warnings and instructions in the Battery Charger Operator’s Manual. Charge the battery until the green indicator on the Battery Charger appears. It takes approximately 30 minutes to reach a full charge with the supplied M12 battery. Any MILWAUKEE M12 Series battery will work with the Thermal Imager.
To avoid damage or injury, use only a genuine MILWAUKEE M12 battery and charger, and follow the charging and handling instructions supplied with the Battery Charger. Snap the battery into place until it locks into the Thermal Imager’s hand grip as shown in Figure 4.
Accessing the SD Memory Card
The SD card is installed in the Thermal Imager at the factory. The Thermal Imager does not store any images without one installed.
To remove and
1.Flip open the rubber dust and water cover toward the front of the Thermal Imager.
2.If an SD card is already installed, you will see it in the upper half of the area under the rubber cover.
3.To remove it, press it in gently and it releases so you can pull it out.
4.If an SD card is not installed, insert the SD card with the label facing the front of the Thermal Imager (the side with the lens). It fits only one way. Do not use excessive force.
5.Gently press it until the SD card clicks and locks in place. Press it again to release it. Leave it locked into place and close the rubber dust and water cover.
Figure 3. Installing the SD Card
8 | M12 160x120 Thermal Imager Operator’s Manual |