Mellerware 3 5 5 3 0 Anti-Freezesetting, Using Of Booking Timer, c. Auto, a. Auto on, b. Auto off

5.) ANTI-FREEZE SETTING

Press the “power setting” button and it is recommended to select the maximum power level. Set the temperature to 5˚C with the “-“ button. When set this way, the appliance will switch on automatically only if the room temperature falls below 5˚C, to prevent freezing at minimum energy consumption.

6.) USING OF BOOKING TIMER

NOTE: If you want to operate the appliance in the auto mode, press the button “booking timer” to activate it.

I In this mode, the function of the timing will be i invalidated.

Press the button “booking timer” one or more times within 5 seconds to select the booking timing mode, as per the following sequence:

The operating time has a span of 24 hours. Auto on and auto off default value is ”00:00”.

c. Auto

Press the button “booking time” until the LCD appears “AUTO”. This indicates that the auto mode comes into effect. The yellow timing pilot light now lights up.

During operating in the auto mode, you can use the “+” button or “-” to set the desired comfort temperature as described above and the appliance will automatically switch on or off at the preset time

and automatically maintain the preset comfort temperature.

NOTE: Do not press the button “power setting” when operating in the auto mode, this will cancel the function of “booking timer”.

To cancel the function of “booking timer”, press the button “booking timer” until blank appears and wait for 5 seconds or press the button “power setting”, the yellow timing pilot light will go out.

NOTE: To keep the heater’s memory programmed, always leave the heater plugged in at the mains socket. If the heater looses its electricity supply, e.g. switched off at the mains socket or in the event of a power failure, the heater’s programs will be lost, and

AM	AUTO ON	MAX
		C
OFF
	AUTO ON
AM	AUTO	MAX
		C
OFF
	AUTO

PM AUTO ON MAX

C

OFF

AUTO OFF

AMMAX

C

OFF

BLANK

the heater will not work until reset.

This heater includes an overheat protection system that shuts off the heater when parts of the heater

are getting excessively hot. Once it occurs, the heater’s programs will be lost.

To completely shut the heater off, turn the controls and power to OFF, and remove plug from the socket-outlet.

The booking timing mode setting can be circulated as above sequence and the yellow timing pilot light will be on during the heater operating in auto mode.

a. Auto on

When the LCD shows “AUTO ON”, the unit comes into auto power on timing state. To select what time you require the heater to be on, push the button “hour” and “minute” until your required operating time appears.

b. Auto off

When the LCD shows “AUTO OFF”, the unit comes into auto power off timing state. To select what time you require the heater to be off, push the button “hour” and “minute” until your required operating time appears.