Napoleon Fireplaces GVFS20P General Instructions, General Information, Mobile Home Installation

Page 5

GENERAL INSTRUCTIONS

ANY CHANGE TO THIS HEATER OR ITS CON- TROLS CAN BE DANGEROUS AND IS PROHIB- ITED.

THIS GAS FIREPLACE SHOULD BE INSTALLED AND SERVICED BY A QUALIFIED INSTALLER to conform with local codes. Installation practices vary from region to region and it is important to know the specifi cs that apply to your area, for example: in Massachusetts State:

The appliance off valve must be a “T” handle gas cock.

The fl exible connector must not be longer than 36 inches.

The appliance is not approved for installation in a bedroom or bathroom unless the unit is a direct vent sealed combustion

product.

WARNING: This product must be installed by a licensed plumber or gas fi tter when installed within the commonwealth of Massachusetts.

Un-vented room heater shall be installed in accordance with 527 CMR 30.00 and 248 CMR 3.00 through 7.00.

Sellers of un-vented propane or natural gas-fi red space/room heaters shall provide to each purchaser a copy

of 527 CMR 30.00 upon the sale of the unit from http://www.napoleonfi replaces.com/Webshare/installation_

manuals/mass_requirements.pdf

In absence of local codes, install the GVFS20 to the current National Fuel Gas Code, ANSI Z223.1 Installation Code which can be obtained from:

American Nation Standards Institute Inc.

1430 Broadway

New York, NY 10018

or

National Fire Protection Association Inc.

Batterymarch Park

Quincy, MA 02269

The fi replace and its individual shutoff valve must be discon- nected from the gas supply piping system during any pressure testing of that system at test pressures in excess of ½ psig (3.5 kPa). The fireplace must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psig (3.5 kPa).

The stove, when installed with a blower, must be electrically connected and grounded in accordance with local codes. In the absence of local codes, use the current ANSI/NFPA 70 NATIONAL ELECTRICAL CODE. The blower power cord must be connected into a properly grounded receptacle. The grounding prong must not be removed from the cord plug.

5

GENERAL INFORMATION

FOR YOUR SATISFACTION, THIS FIREPLACE HAS BEEN TEST-FIRED TO ASSURE ITS OPERATION AND QUALITY! Maximum input is 23,000 BTU/hr for natural gas and propane. When the fi replace is installed at elevations above 2,000ft, and in the absence of specifi c recommendations from the local authority having jurisdiction, the certifi ed high altitude input rating shall be reduced at the rate of 4% for each ad- ditional 1,000ft.

This heater must not be installed in a bedroom or bath- room.

This fireplace is only for use with the type of gas indi- cated on the rating plate. This fireplace is not convertible

for use with other gases, unless a certified kit is used.

Minimum inlet gas supply pressure is 4.5 inches water col- umn for natural gas and 11 inches water column for propane. Maximum inlet gas pressure is 7 inches water column for natural gas and 13 inches water column for propane. Manifold pressure under flow conditions is 3.5 inches water column for natural gas and 10 inches water column for propane.

No external electricity (110 volts or 24 volts) is required for the gas system operation. Expansion / contraction noises during heating up and cooling down cycles are normal and are to be expected.

This heater is equipped with a pilot light safety system referred to as an OXYGEN DEPLETION SENSOR and is designed to turn off the heater if not enough fresh air is available.

Use only accessories designed for and listed

with your specific fireplace.

MOBILE HOME INSTALLATION

Suitable for mobile home installation where the mobile home has been permanently placed on its site.

This fireplace may be installed in an aftermarket permanently located, manufactured (mobile) home, where not prohibited by local codes.

For mobile home installations, the fi replace must be fastened in place. It is recommended that the fi re- place be secured in all installations. Use the levelling / securing kit, GDSLL-KT, for this purpose.

W415-0559 / 02.15.06

Image 5
Contents W415-0559 What to do if YOU Smell GAS Table of Contents Napoleon GAS Fireplace Presidents Lifetime Limited Warranty General Information Mobile Home InstallationGeneral Instructions GVFS20 Pilot Indicator Light Battery ReplacementLocation & Clearances GAS Installation Blower InstallationFinishing Cast Front Installation Screen InstallationLogo Placement LOG and Logo PlacementOperating Instructions OperationOxygen Depletion Sensor Pilot Cleaning AdjustmentsVenturi Adjustment Accessories ReplacementsReplacement Parts W415-0559 Symptom Problem Test Solution Trouble Shooting GuideLeak test with a soap and water solution Fireplace Service History

GVFS20P, GVFS20N specifications

The Napoleon Fireplaces GVFS20P and GVFS20N gas fireplaces are elegant and functional additions to any living space, offering a blend of modern technology and classic aesthetics. These versatile units are designed to enhance the ambience of your home while delivering efficient heating solutions.

One of the standout features of the GVFS20P and GVFS20N is their customizable design. Available in both propane and natural gas models, these fireplaces allow homeowners to select the fuel type that best suits their needs. This adaptability makes them a popular choice among consumers looking for flexibility in their heating options.

The GVFS series boasts a compact design, making it suitable for various living spaces, including smaller rooms that may not accommodate traditional fireplaces. With a viewing area that maximizes flame exposure, these models elegantly showcase the dancing flames, creating a cozy atmosphere.

Equipped with Napoleon's patented PHAZER log set and glowing ember bed, the GVFS20P and GVFS20N replicate the natural look of a wood-burning fireplace. The realistic flames, combined with the realistic log set, provide a stunning visual experience while ensuring efficient heat production. Moreover, the inclusion of a tempered glass front helps prevent heat loss, allowing for optimal energy efficiency.

The GVFS models are also equipped with advanced technology features, including a Bluetooth-enabled remote control that allows users to adjust the flame height and heat output from the comfort of their seating area. This user-friendly interface maximizes convenience, enabling you to create the perfect ambiance with just a few clicks.

Another key characteristic of these fireplaces is the patented firebox design that enhances combustion efficiency while reducing exhaust emissions. This technology ensures that both models meet strict environmental standards while delivering impressive heating performance. The GVFS20P and GVFS20N also come with safety features, including an automatic shut-off system that contributes to peace of mind for users.

In summary, the Napoleon Fireplaces GVFS20P and GVFS20N stand out in the market for their aesthetic appeal, advanced technologies, and user-friendly features. With their beautiful flame display, customizable options, and commitment to efficiency and safety, they represent a superb choice for anyone looking to enhance their home with a modern gas fireplace solution. Whether you prioritize design, functionality, or environmental responsibility, these models deliver on all fronts, making them a worthwhile investment for any cozy living space.