Monessen Hearth EYF18, EYF24 manual Installation, Heat Resistant Material

INSTALLATION EYF Series Unvented Gas Log Set

Heat resistant material (minimum requirements) with wooden mantel or other combustible projection: To install the heater with a wooden mantel, shelf or other combustible projection above, first measure the heat resistant material shown in Figure 6, then refer to Table B.

Figure 6 -

Mantel Clearance with Hood

8" or More of Heat Resistant Material

Hood

Heater in

Fireplace or

Firebox

FP2532

Table B -

Heat Resistant Material Heights and Mantel Location

	EYF24/18 Requirements
	for Safe Installation with
Heat Resistant Material	Wooden Mantel, Shelf or
Measurement	Other Combustible
	Projection
20" or more	Hood not required. Figure 6
8" to less than 20"	Install hood (CABR/CABL)
	and refer to Figure 7; OR
	extend heat resistant material
	to at least 12" and refer to
	Figure 8.
Less than 8"	Extend heat resistant material
	to at least 8" and install hood
	(CABR/CABL), refer to
	Figure 6. OR, extend heat
	resistant material to a height
	of at least 12" and refer to
	Figure 8.

65D1009

	12”
6” - 10”
256O”
Heat	20”
Resistant
	18”
Material
8”	13”
Min
Hood
Heater in Fireplace
or Firebox
FP2534

Figure 7 -

Minimum Mantel Clearance with Hood

Example: A mantel may project from the wall a maximum of 2Z\x" at a minimum of 13" above the opening and a maximum of 10" at a minimum of 18" above the open- ing.

10” or Less

32”

Heat

Resistant

Material

20”

Min.

Heater in Fireplace

or Firebox

FP2535

Figure 8 -

Minimum Mantel Clearance with No Hood

Example: The bottom of the mantel may project from the wall a maximum of 10" at a minimum of 32" above the opening.