Monessen Hearth DEB20, DEB30 manual LOG Placement, Installing Logs on Grate See Figures 25

Page 26
Left Front Pin

LOG PLACEMENT

Before you begin — This unit is supplied with four or five ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with soap and water to remove any traces of fibers.

WARNING

The positioning of the logs are critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance. Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to the heater. Only use the logs supplied with the unit.

Failure to position the parts in accordance with diagrams below or to use only parts specifically approved for this heater may result in property damage or personal injury.

INSTALLING LOGS ON GRATE (See Figures 25 and 26 )

NOTE: Model DEB18 has 4 logs and models DEB24 and DEB30 have 5 logs.

1.Install back log (#1) on two pins located near the back of base. Check log position and stability.

2.Install right center log (#2) on pins located near right front of base and center of base.

NOTE: The #2 log is a heat shield for the control valve. It is critical that this log is sitting in its pin placement and completely down with the front noise of the embers placed below the front burner. If the #2 log is not placed properly it could cause damage to the control valve and wiring.

3.Install left center log (#3) on pin located near left front of base and on top of right center log (#2).

4.Install middle front log (#4) in front of center log. Make sure bottom of log is resting on the center of grate. Do not let log #4 contact the front burner.

5.DEB 24 and DEB 30 only: Rest right end of left front log (#5) on log #3 and the top of left front log on log #1.

6.Place back end of top center log (#5) on recessed area of back log (#1). Cross log #6

over log #2 and rest right extension on grate. Log #6 should fit on pin on center log #3.

 

Log #6

 

Log #6

 

 

 

 

 

Log

 

 

Log #4

 

 

 

 

 

#4

 

Log #5

 

 

 

 

 

 

 

Log

(24 & 30

Log

 

only)

Log #3

#1

 

#1

 

 

 

 

Log

 

Log

#3

Log

#2

 

#2

 

Back

 

Back

Pins

 

 

Pins

 

 

 

Left Front Pin

Right Front and

 

Right Front and

Center Pins

 

Center Pins

Figure 25 - Installing Logs

 

Figure 26 - Installing Logs

 

to Grate

to Grate (Model DEB20)

 

(Models DEB24 and DEB30)

26

44D0060

Page 25 Page 27
Image 26
Page 25 Page 27
Contents What to do if YOU Smell GAS Models DEB20, DEB24, DEB30Read and Save These Instructions Contents Owner Important Safety InformationInstaller From Make Sure YOU have Received ALL Parts What YOU will Need for InstallationGetting Started PROPANE/LPG Product Features and SpecificationsNatural GAS Thermal Generator Ignition ControlsPILOT/ODS Adequate Combustion and Ventilation AIR General Installation InformationCodes BTU/Hr = 151/2 x 12 x 8 x 1000 = 29760 BTU/Hr Fireplace and Hearth Dimensions Hearth Minimum DimensionPlacement in a Fireplace with a Restrictive Barrier Height of Restriction Minimum Depth of Fireplace/FireboxClearances and Height Requirements Sidewall and Ceiling ClearancesClearances and Height Requirements Measuring Heat Resistant Material for Mantel Clearances and Height Requirments HeaterExample The bottom of the mantel may project from the wall a Floor Clearance Minimum Clearance above Combustible FlooringBefore Installing the Appliance Installing Vented ApplicationsBefore Fully Installing the Unit Damper Stop InstallationPlacing and Securing Appliance Installing Vented ApplicationsAssembly Procedure Connecting the GAS Flexible Tube Manual Shutoff Gas Supply Inlet ValveChecking GAS Pressure Manual Control FigureATE Electrical Wiring MILLI-VOLTConnecting Optional Wall Switch or Thermostat Connecting Remote Receiver Installing T-STAT Sensor Option Sold SeparatelyInstalling T-Stat Sensor to DEB Base With Screw Provided Complete MILLI-VOLT System Check Operation of Thermostat SensorChecking System Operation LOG Placement Installing Logs on Grate See Figures 25Checking the Pilot Flame Flame AppearancePlacing the Decorative Rock MILLI-VOLT ControlChecking the Burner Flame Operating InstructionsOperating Instructions What to do if YOU Smell GASManual Control Lighting Instructions MILLI-VOLT Control Lighting Instructions Operating Instructions and Cleaning and Servicing Cleaning and ServicingTroubleshooting Observed Problem Possible Cause RemedyODS/pilot lights, but flame Replacement Parts Burner AssemblyReplacement Parts List DEB20 DEB24/DEB30Logs DEB20 DEB24 DEB30Special Requirements Special Requirements Basic Warranty Lifetime WarrantyFive Year Warranty

DEB20, DEB30 specifications

Monessen has long been synonymous with quality and innovation in the hearth industry, and the Monessen Hearth DEB20 and DEB30 models are prime examples of their commitment to excellence. These direct vent gas fireplaces provide a stylish and efficient solution for heating and enhancing the ambiance of any home.

One of the standout features of both the DEB20 and DEB30 is their versatile design. Available in different sizes, the DEB20 is tailored for smaller spaces, while the DEB30 is ideal for larger areas, ensuring that homeowners can select a model that fits their specific needs. Both units are equipped with a minimalist design that allows them to seamlessly integrate into various decor styles, from modern to traditional.

Another important characteristic of the DEB series is their use of advanced technology for efficient operation. The direct vent system ensures that combustion gases are vented outside, providing a safer and cleaner indoor environment. This feature not only enhances the air quality in your home but also allows for flexible installation options, as venting can be engaged through walls or roofs.

The Monessen DEB20 and DEB30 models also boast a variety of aesthetic customizations. They come with an array of decorative options, including different media choices like glass, logs, or stones, allowing homeowners to create a truly personalized look. Optional features such as remote control operation provide additional convenience, allowing users to adjust flame height and heat output at the push of a button.

Energy efficiency is another hallmark of these fireplaces. Both the DEB20 and DEB30 are designed to maximize heat output while minimizing gas consumption, making them an economical heating solution. They also feature adjustable flame settings to meet various heating requirements, ensuring that warmth can be tailored to personal preference.

In summary, the Monessen Hearth DEB20 and DEB30 units exemplify a marriage of style and function, driven by cutting-edge technology and thoughtful design. With their efficient heating capabilities, customizable aesthetics, and safe operation, these fireplaces offer a compelling choice for anyone looking to enhance their home's warmth and charm. Whether it's for cozy family gatherings or quiet evenings, the DEB series is sure to deliver comfort and elegance.
Top Page Image Contents