Napoleon Fireplaces EF30G manual Maintenance, Flame generation bulb replacement

Page 17

17

6.0 maintenance

!WARNING

Always disconnect the power and allow the electric fireplace to cool before performing any cleaning, maintenance or relocation of this electric fireplace. Turn controls to OFF and remove plug from outlet or turn off the house circuit breaker to electric fireplace receptacle.

Do not install replacement bulbs that exceed specified maximum watts.

The halogen light bulbs in your unit can become extremely hot. Allow at least 10 minutes between turning off the fireplace and removing the light bulbs to avoid accidental burns. Do not handle the lamp (bulbs) with bare fingers, oils from your skin will damage the bulbs whey they heat up. Use gloves or a clean dry cloth when handling bulbs.

Most halogen light bulbs are rated to last approximately 1800 hours. Like all light bulbs, halogen bulbs require periodic replacement. When the bulbs in your appliance have burned out you will notice one or more of following:

Common Observed Problems:

-There is no flame

-Flame or Ember bed is dim or dark in certain areas

-Flame is not moving or glowing

Your appliance appliance must be opened in order to replace the light bulbs. To reduce the number of times you need to open the appliance, replace all bulbs at the same time if they are close to the end of their rated life.

There are a total of 8 halogen light bulbs (Type GX6.35, rated 120Volts, 35Watts) in your appliance:

- 2 bulbs provide illumination for the ember bed

- 2 bulbs provide illumination for flame generation - 4 extra bulbs for replacement

FIGURE 6.0

6.1 flame generation bulb replacement

FIGURE 6.1.1

 

6.1.1Remove the 7 screws from the bottom half of the back of appliance as illustrated. Remove back plate.

6.1.2a Locate the flame generation cylinder drum. It is constructed of two removable halves. They are two (2) matte black sheet metal pieces with holes in them, either of which can be removed from the appliance.

6.1.2b Remove the screw as illustrated that are used to secure the flame generation cylinder drum.

6.1.2c Squeeze half of drum cylinder until its top edge clears the top drum track. Remove the bottom edge of the cylinder drum from the bottom drum track. This will give you access to the light bulbs. Note: Do not exert excessive pressures on the drum cylinder as this may cause damage.

FIGURE 6.1.2

tp - maintenance warning

W415-0760 / 12.19.08

Page 16 Page 18
Image 17
Page 16 Page 18
Contents EF30G Introduction Table of contentsConditions and Limitations WarrantyGeneral instructions PrecautionsEF30G Listing approvalsUnpacking and testing appliance DimensionsLocating appliance Not CoverGrounding appliance Electrical requirementsElectric Diagram Hardwire installationW415-0760 Before Installation InstallationMinimum clearance to combustibles New construction or renovationGlass Front Bottom Tray Screws Installing the applianceGlass ember installation Thermostat and thermal sensor installation Framing Minimum mantel clearances Finishing checklistPlug in your electric appliance Operating instructionsRemote control Flame generation bulb replacement MaintenanceCleaning Ember bed bulb replacementREF no EF30S Description ReplacementsRequired to Honour the Claim Troubleshooting

EF30G specifications

The Napoleon Fireplaces EF30G is a stunning addition to any home, combining cutting-edge technology with sophisticated design. As part of Napoleon’s high-quality fireplace line, the EF30G boasts a range of features that enhance both aesthetics and functionality.

One of the most notable characteristics of the EF30G is its impressive heating capacity. With a powerful output, this fireplace can efficiently warm up spaces of varying sizes, ensuring comfort during the cold months. The unit’s 30-inch design is perfect for both contemporary and traditional interiors, offering a sleek and elegant appearance that complements any décor.

A standout feature of the EF30G is its advanced heat management system. Equipped with a high-efficiency burner, this fireplace generates warmth while minimizing energy consumption. The Eco-Friendly technology ensures that the fireplace operates at peak efficiency, which not only saves on utility bills but also reduces environmental impact.

The EF30G also includes customizable flame settings that can be adjusted according to personal preference. With a realistic flame presentation that mimics the look of traditional wood-burning fireplaces, it offers the ambiance of a natural fire without the hassle of wood. The fireplace includes various media options, allowing homeowners to choose from logs, crystals, or stones to further personalize their fire’s appearance.

In terms of safety, the EF30G is designed with a range of safety features. The unit boasts a heat-resistant glass that remains cool to the touch, preventing accidental burns. The built-in safety shut-off function ensures peace of mind, automatically turning off the fireplace in case of an overheating situation.

Installation and maintenance of the EF30G are also simplified. The fireplace can be easily integrated into new constructions or retrofitted into existing spaces due to its flexible venting options. With minimal maintenance required, users can enjoy the beauty and warmth of their fireplace without the burdens of extensive upkeep.

Overall, the Napoleon Fireplaces EF30G combines style, efficiency, and safety, making it an ideal choice for anyone looking to enhance their home. Whether for cozy evenings or festive gatherings, this fireplace is sure to be a focal point that provides warmth and elegance for years to come.
Top Page Image Contents