11
TROUBLE SHOOTING GUIDE
| SYMPTOM | PROBLEM | TEST SOLUTION |
| |
|
|
|
|
|
|
| No Flame Light but | - | Light bulbs have burned out. | - Remove access panel and change | |
| everything else is | - | Light could be loose. | light bulbs. | |
| working properly. |
|
| - Remove access panel and tighten light bulb. | |
|
|
|
|
|
|
| Flame light, but no | - | Flame generator motor has burned out. | - Consult your local dealer. | |
| movement in the flame | - | Flame generator has come loose. | - Remove the access panel and check to make | |
|
|
|
| sure the flame generator is in the flame | |
|
|
|
| generator bracket, and is secured to the | |
|
|
|
| motor with the rubber tube. | |
|
|
|
|
|
|
| Remote control | - | Dead batteries. | - Make sure batteries are charged. | |
| not working | - | No power to the unit. | - Make sure main power is on. | |
|
| - | Power turned off. | - Turn on manual power switch. | |
|
|
|
|
| |
| Heater works but | - | Fan on heater is not working. | - Consult your local dealer. | |
| there is no air flow. | - | Air inlet is blocked. | - Check that there is nothing blocking the air | |
|
|
|
| inlets at either side near the bottom of the | |
|
|
|
| fireplace. | |
Fan works but there is - Heater is not working. no heat.
- Consult your local dealer.
Fireplace will not | - | Breaker or fuse has blown. |
turn on. | - | Fuse on circuit board may be blown |
|
| or loose. |
-Check main power switch is turned on.
-Consult your local dealer.
| Heater does not turn off. - | Thermostat is set to high. | - Turn thermostat | ||
|
| - Thermostat may be faulty. | - Consult your local dealer. | ||
|
|
|
|
| |
| Excessive noise coming - | Dirt build up on fan bearing. | - Consult your local dealer. | ||
| from the top of the unit. | - | Defective blower. | - Vacuum the top control compartment. | |
|
|
|
|
|
|
| Odour | - | Dust has settled on the | - Run heater until odour ceases | |
|
|
| heater element. | (approx. 1/2 hr) | |
|
|
|
| - Consult your local dealer. | |
|
|
|
|
|
|
| Heater cycling on | - | Air intlets blocked. | - Check to make sure there is nothing blocking | |
| and off |
|
| the air inlets on the bottom of the unit. | |
|
|
|
| - Should not be on high pile carpet that can | |
|
|
|
| block air inlets. | |
|
|
|
|
| |
| The fireplace turns off | - | Fuse may be loose | - Consult your local dealer | |
| when moved or bumped. |
|
| (Remove the 5 screws from the control panel | |
|
|
|
| and check that the fuse is not blown or loose.) | |