Wall Mounting and Attaching the Wheels
Wall mounting
1.Before wall mounting your heater, remove the wheels.
2.Mark the screw location on the wall, approximately 1 metre from the floor.
Note: The heater must be fixed no lower than 6.5cm above the floor and no higher than 1.8 metres above the floor. The heater must also be fixed at least 1 metre from both the corner and ceiling (refer to figure 4 below).
Drill the first hole using a suitable drill bit.
����
����
Figure 5
3.Insert one of the screw anchors into the hole.
�� | 4.Put the mounting support on the wall over | |
the hole and screw it into place. | ||
���� | ||
�� | 5.Mark the second screw location, | |
approximately 138mm from the first hole, | ||
| ||
| and 1 metre from the floor. Drill the second | |
����� | hole. | |
|
6.Insert the second screw anchor into the hole.
Figure 4
Note: Any electrical appliances to be fitted in a bathroom should be installed by a qualified electrician in accordance with Australian/New Zealand Standard Wiring Rules. Portable heaters should not be used in a bathroom.
Heaters that can be permanently fixed must be installed so that any controls cannot be reached by a person using a bath or shower, as shown in Figure 5.
7.Place the mounting support over the second hole and screw it into place. Tighten both screws.
8.Lift the heater and position over the screws.
Attaching the wheels
Fix each wheel support in position with the screws provided.
11