Sunbeam Bedding HE3100, HE3900 manual Using the remote control, Setting the digital thermostat

Page 11

Using your Convection Plus Heater continued

HE3900 – 2200W heater with micathermic elements and remote control

1.Place the heater on a flat level surface and ensure that the air intake and outlet are clear of obstructions.

(Refer to Note on Page 8).

2.Ensure that the ON/OFF switch is in the OFF position.

3.Insert the plug into a 230/240V power outlet and turn the power on. Move the ON/OFF switch (located on the side of the heater) to the ON position. The ON/OFF switch will then illuminate.

The LCD screen will display the ambient room temperature.

Note: When the heater is switched on it will be automatically set to the standby mode.

4.Press the mode button to select your desired operating mode. Each time you press the mode button, it will scroll through the various settings as follows:

STANDBY

the heater remains inactive

when in this mode

LO

the heater will continuously run

at approximately 800 watts

 

HI

the heater will continuously run

at approximately 2200 watts

 

AUTO

for operating the digital

thermostat

 

5.To turn the heater off, move the ON/OFF switch to the OFF position.

Using the remote control

The remote control allows you to conveniently operate the heater from anywhere in the room.

The buttons on the remote control are identical to the buttons on the heater. When using your remote control simply follow the normal operation instructions outlined on pages 9 and 10 in addition to the points below.

1.Ensure that the remote control contains 2 x AAA batteries.

2.Point the remote towards the infrared receiver on the heater (located below the plus/minus arrows). Ensure that there are no objects blocking the path between the remote and the infrared receiver.

3.Follow steps 1 to 4 on the left column of this page.

Note: The maximum transmission distance between the heater and remote is approximately 30 metres.

Setting the digital thermostat

The digital thermostat allows you to set your desired temperature for the room. The heater will then cycle on and off to maintain it.

1.Follow steps 1 to 3 on the left column of this page.

2.Press the mode button until the AUTO mode is displayed. Once in AUTO mode, the LED screen will flash your previous pre-set temperature for 5 seconds. After

5 seconds the LED screen will display the ambient room temperature.

9

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Convection Plus Heaters Important instructions retain for future use ContentsEnsure the above safety precautions are understood Sunbeam’s Safety PrecautionsFor examination, repair or adjustment Always unplug the heater when not in use Do not use outdoors Instant tip-over cut-out Sunbeam’s Total Safety SystemSafety auto shut-off Thermal back-up fuseHandle and wheels Features of your HE3100 Convection Plus HeaterDouble heat micathermic elements Wall mountableAdjustable thermostat Power on lightMode dial Thermostat indicator lightFeatures of your HE3900 Convection Plus Heater Timer button Remote controlON/OFF switch Mode buttonUsing your Convection Plus Heater Setting the digital thermostat Using the remote controlTimer auto on function Using the timerTimer auto OFF function Set the heater to the desired setting using the mode buttonAttaching the wheels Wall Mounting and Attaching the WheelsWall mounting Care and Cleaning Australia 1800 025 New Zealand 0800 786 New Zealand Australia
Top Page Image Contents