Sunbeam Bedding HE2100 manual Using the Oscillation Function, Resetting the safety auto shut-off

Page 9

Using the Oscillation Function

The 90 degree oscillation function can be used in any mode except standby.

1.Press the oscillation button (OSC), positioned on the top of the heater. The heater will then begin to oscillate from side to side.

2.To stop the heater from oscillating, simply press the oscillation button (OSC) once again.

Resetting the Total Safety System

Resetting the safety auto shut-off

The safety auto shut-off detects any abnormally high temperatures within the heater and shuts it off to prevent overheating. Should the safety auto shut-off activate and switch off the heater, it will need to be reset.

1.To reset the heater, press the mode button until the standby mode is selected.

2.Unplug the heater and wait 10 minutes for the unit to cool down.

3.After 10 minutes, plug the heater in again and operate as usual.

Resetting the thermal backup device

In addition to the safety auto shut-off, your heater also contains a thermal back-up device for additional protection. Should the thermal back-up device activate and switch off the heater it will need to be reset.

To reset the heater, follow steps 1 to 3 on this page.

7

Image 9
Contents Compact Ceramic Oscillating Heater Contents Sunbeam’s Safety Precautions For examination, repair or adjustmentEnsure the above safety precautions are understood Important instructions retain for future use Sunbeam’s Total Safety System Safety auto shut offThermal back-up device Fan setting Mode buttonPower on light Safety auto shut-offElectronic thermostat Oscillation functionThermostat dial Ceramic elementSetting the electronic thermostat Using your Compact Oscillating Ceramic HeaterResetting the safety auto shut-off Using the Oscillation FunctionResetting the thermal backup device To reset the heater, follow steps 1 to 3 on thisCare and Cleaning Troubleshooting GuideAustralia 1800 025 New Zealand 0800 786 12/05 New Zealand Australia