Sunbeam Bedding HE2100 manual Sunbeam’s Safety Precautions, For examination, repair or adjustment

Page 3

Sunbeam’s Safety Precautions

Sunbeam are very safety conscious when designing and manufacturing consumer products, but it is essential that the product user also exercise care when using an electrical appliance. Listed below are precautions which are essential for the safe use of an electrical appliance:

Read carefully and save all the instructions provided with an appliance.

Always turn the power off at the power outlet before you insert or remove a plug. Remove by grasping the plug - do not pull on the cord.

Turn the power off and remove the plug when the appliance is not in use and before cleaning.

Do not use your appliance with an extension cord unless this cord has been checked and tested by a qualified technician or service person.

Always use your appliance from a power outlet of the voltage (A.C. only) marked on the appliance.

This appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible adult to ensure that they can use the appliance safely.

Young children should be supervised to ensure that they do not play with the appliance.

Never leave an appliance unattended while in use.

Do not use an appliance for any purpose other than its intended use.

Do not place an appliance on or near a hot gas flame, electric element or on a heated oven. Do not place on top of any other appliance.

Do not let the power cord of an appliance hang over the edge of a table or bench top or touch any hot surface.

For safety reasons and to avoid maintenance by unskilled persons, some appliances are ‘sealed’ using tamperproof screws. Such appliances should always be returned to the nearest Sunbeam Appointed Service Centre for adjustment or repair if required.

Do not operate any electrical appliance with a damaged cord or after the appliance has been damaged in any manner. If damage is suspected, return the appliance to the nearest Sunbeam Appointed Service Centre

for examination, repair or adjustment.

For additional protection, Sunbeam recommend the use of a residual current device (RCD) with a tripping current not exceeding 30mA in the electrical circuit supplying power to your appliances.

Do not immerse the appliance in water or any other liquid unless recommended.

If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.

Ensure the above safety precautions are understood.

1

Image 3
Contents Compact Ceramic Oscillating Heater Contents Sunbeam’s Safety Precautions For examination, repair or adjustmentEnsure the above safety precautions are understood Important instructions retain for future use Sunbeam’s Total Safety System Safety auto shut offThermal back-up device Safety auto shut-off Mode buttonFan setting Power on lightCeramic element Oscillation functionElectronic thermostat Thermostat dialSetting the electronic thermostat Using your Compact Oscillating Ceramic HeaterTo reset the heater, follow steps 1 to 3 on this Using the Oscillation FunctionResetting the safety auto shut-off Resetting the thermal backup deviceCare and Cleaning Troubleshooting GuideAustralia 1800 025 New Zealand 0800 786 12/05 New Zealand Australia