INSTALLATION
AERATION
ADJUSTMENT
The burner aeration is factory set but may need adjusting due to either the local gas supply or altitude.
F38-2 with 38 mj
NG: | Full open | |
LPG: | 6.4 mm open |
Caution: Carbon will be produced if the air shutter is closed too much.
Note: Any damage due to carboning re- sulting from improperly setting the aeration controls is NOT covered under warranty.
LOG SET
INSTALLATION
Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.
The gas log kit contains the following:
a)
b)
c)
d)
e)
f)
g)
h) | Embers | |
i) | Lava |
Note: Install Optional Brick Panels prior to installing logs.
The "02" refer numbers (i.e.
molded into the rear of each log.
1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.
2)Sprinkle the embers on the left and right sides of the firebox base.
3)Place Rear Log
Pins on Rear Log Support
4)Place the Middle Left Log
5)Place Front Left Log
Embers.Embers
Regency | 9 |
