Vornado SF-140 warranty Assembling Your Everyday Steam Mop, Telescopic Pole

Assembling Your

Everyday Steam Mop

TELESCOPIC POLE

1.Connect Handle to upper (thicker) end of Telescopic Pole. To do this, simply slide Handle onto pole until it snaps in place (FIGURE 1-A).

NOTE: Once connected, the Handle is not designed to be removed from the Telescopic Pole. If it becomes necessary to remove it, contact Consumer Service for assistance (Page 13).

2.Insert lower (thinner) end of Telescopic Pole into yoke on top of Mop Head. When inserting, make sure release button located on pole faces towards back side of yoke as illustrated (FIGURE 1-B).

3.Press Telescopic Pole into yoke until release button snaps through small hole on back side of yoke (FIGURE 1-C). Telescopic Pole should now be secured to Mop Head.

NOTE: In order to coax the release button through the hole, it may be necessary to rotate and adjust the Telescopic Pole until button aligns properly with hole.

4.To adjust length of Telescopic Pole, press Extension Lock downward. While holding lock down, move the upper section of pole until it is at the desired length (FIGURE 1-D). Release lock, then adjust upper section of pole again until it “clicks” securely into place.

5.To disconnect Telescopic Pole, swivel lower Cord Bracket 180º upward, then press firmly on release button while simultaneously pulling pole away from Mop Head yoke (FIGURE 1-E).

1-A 1-B 1-C 1-D 1-E

FIGURE 1

6 ENGLISH