Vornado SF-140 warranty Using Your Everyday Steam Mop, Adding Water

Using Your

Everyday Steam Mop

ADDING WATER

1.Make sure On/Off Switch is set to “off” position (red Power Indicator Light will not be illuminated) and power cord is unplugged.

2.Carefully remove Boiler Cap by unscrewing it in a counter-clockwise direction (FIGURE 3-A).

3.If Boiler was not emptied completely after last use, empty all remaining water now to prevent overfilling.

4.Fill included Measuring Cup with 8.5 oz. (250 ml.) water, and pour into Boiler through Boiler Fill Hole (FIGURE 3-B).

NOTE: In order to minimize potential mineral build-up and prolong the life of your Everyday Steam Mop, it is recommended that distilled or de-mineralized water be used in the Boiler.

If distilled water is not available, then Boiler should be cleaned frequently in order to remove mineral build-up. Refer to Mineral Build-Up section on Page 11 for details.

5.For maximum usable water (10 oz. / 300 ml.), fill Measuring Cup with another 1.5 oz. (50 ml.) of water, and add into Boiler.

6.Replace Boiler Cap by screwing it into Boiler Fill Hole in a clockwise direction until tight (FIGURE

3-C). Unit is now ready to begin steaming – refer to Page 9 for operating instructions.

REFILLING

If unit has been in use, always take the following safety precaution before removing the Boiler cap and adding water:

•Allow unit to cool for 5-10 minutes. This will reduce heat and pressure inside the Boiler, helping to prevent escaping steam when the Boiler Cap is removed as well as vaporization when more water is added.

Once this is done, follow Adding Water procedure above as usual.

WARNING: Failure to follow this precaution may result in burns from escaping steam when the Boiler cap is removed or when water is poured into the Boiler.

3-A

3-B

3-C

FIGURE 3

8 ENGLISH