HOW to USE

Using your Vornado Heater is easy. Just follow these simple steps.

1.Position your heater so the vortex beam of warm air is directed across the room unobstructed. Position it in a location that

is representative of the room temperature. Avoid areas of temperature extremes such as cold drafts and heat registers. Please refer to IMPORTANT INSTRUCTIONS at the beginning of this owner’s guide.

2.Plug into a standard grounded wall outlet.

3.Press the POWER button.

4.One-Knob Operation

This innovative user interface is sophisticated yet simple. Press the knob to “wake-up” or turn on the screen on the base unit, rotate the One-Knob control unit until the desired mode you want to adjust is displayed. Press the button to accept this mode, then, rotate the knob left or right to select desired setting. The unit is then set, or you may press the One-Knob again to adjust another mode, and continue to adjust additional settings in the same manor.

5.Remote Control

Fully control the Heater remotely with the Remote, no more getting up to adjust the temperature. You can turn the unit ON and OFF, switch the mode from FAN ONLY, to LOW HEAT or HIGH HEAT, adjust the desired set temperature up or down, and set the automatic-off timer. As you adjust the remote, the base unit will “beep” to indicate that it has received your signal.

CARE & MAINTENANCE

iCONTROL OPERATING CONTROLS

Your heater has no user serviceable parts. Do not disassemble the unit – it will void your warranty. If service is required, return your heater to Vornado (see Warranty section).

The motor is permanently lubricated and requires no oiling.

Because your heater moves a substantial amount of air, it will require regular cleaning. Be sure to unplug the unit prior to any cleaning activity.

Use a vacuum cleaner with the brush attachment to clean any accumulated dust on the front grill and the side air inlets. During the off-season or extended periods of non-use, store your heater. Unplug the unit and bundle the cord. Save the plastic bag the heater was shipped in so you can cover the unit and minimize settling dust.

1POWER ON/OFF

Front light illuminates when power is on.

2MODE

HIGH HEAT 1500 watts, LOW HEAT 750 watts, or FAN ONLY.

3TEMPERATURE

Allows you to select your desired comfort level. Use the UP arrow to raise the set temperature. Use the DOWN arrow to lower the set temperature.

4TIMER

The timer can be set in hour intervals up to 9 hours. Press the TIMER button to go into timer mode. In timer mode, use the UP arrow to add hours. In timer mode, use the DOWN arrow to remove hours.

5REMOTE

The remote control functions the same as the unit controls. The remote requires 2 AAA batteries. To replace the batteries remove the cover located on the bottom side of the remote.

6SOUND

When a setting is changed you will hear a “beep” from the unit.

7LCD DISPLAY

Dims for no-glow night operation.

14 Español

Español 15