Vermont Casting 1920 installation instructions Specifications, Aspen, Model

Aspen Woodburning Stove

Specifications

Aspen, Model 1920

EPA Emissions rating	............... 4.3 (g/h, non-catalytic)*
Maximum heat output	..........................18,000 Btu’s/hr.1
Area heated	Up to 600 sq. ft. (56 sq. m)2
Fuel size/type	16” (41 cm) logs
Loading	Front
Chimney connector	6” (152 mm) diameter
Chimney flue size	6” (152 mm) minimum
Flue exit position	Reversible, top or rear

Primary air ...	Manually set, thermostatically maintained
Ash handling system		Removable ash pan
Glass panel	High-temperature ceramic
Weight		240lbs. (576kg)
Width (Left leg - Right leg)		16” (406 mm)
Depth (Front leg - Rear leg)		23” (584 mm)
Height to top of top exit flue collar		24” (610 mm)
Height to top of rear exit flue collar		21” (533 mm)

1This value can vary depending on how the stove is op- erated, the type and moisture content of the fuel used, as well as the design, construction and climatic location of your home. Figures shown are based on maximum fuel consumption obtained under laboratory conditions and on average efficiencies.

2These values are based on operation in building code- conforming homes under typical winter climate condi- tions in New England. If your home is of nonstandard construction (e.g., unusually well insulated, not insu- lated, built under ground, etc.) or if you live in a more severe or more temperate climate, these figures may not apply. Since so many variables affect performance, consult your Vermont Castings authorized dealer to determine realistic expectations for your home.

15"

(381 mm)

24" (610 mm) Top Exit Flue Collar

Height

7���"

(184 mm)

16"

(406 mm)

7���"

(191 mm)

6"

(152 mm)

22���"

(565 mm)

C

L

22���"

(570 mm)

18"

(457 mm)

23"

(584 mm)

3069

Fig. 1 Aspen 1920 specifications.

30000369 3