Using your Eco Mop (continued)
Note: When cleaning large areas the floor cloth may become quite wet and/or dirty. Move the steam on/off switch to the off position (
) and unplug the mop from the power outlet. Allow the used cloth to cool before removing to rinse, wring out and replace. Alternatively replace with a clean, dry cloth. Follow the instructions on this page if using a
7.Should the mop run out of steam during use the water tank may be empty and may need refilling. Place the mop on the tray provided, move the steam on/off switch to the off position (
) and remove the plug from the power outlet. Refill the mop according to the instructions on page 7.
Note: Do not use the mop without water in the tank as this may damage the mop. Always refill immediately once the generator becomes noticeably louder, as this indicates that the water tank needs refilling.
8.Once you have finished cleaning the desired area, move the steam on/off switch to the off position (
) and remove the plug from the power outlet. Place the mop on the tray whilst cooling.
9.Allow the mop to cool completely before storing.
Using a non-elasticised cloth
Before removing a cloth from the utility head, ensure that the steam on/off switch is in the off position (
) and the plug is disconnected from the power outlet. Allow the mop, the utility head and the cloth to cool before handling.
When using a
Remove the utility head from the mop before fitting the cloth.
Figure 11
1.Pull each clip upwards and twist 90°.
2.Place the utility head on a clean dry cloth and fold the edges of the cloth up over the sides of the head.
3.Twist the clips back into position so that the cloth is secured underneath them.
4.Follow steps 2 to 9 on page 7.
Using the other attachments
Before removing an attachment from the mop, ensure that the steam on/off switch is in the off position (
) and the plug is disconnected from the power outlet. Allow the mop and the attachment to cool completely before handling.
To remove an attachment, depress the button on the end of the mop and slowly pull while rotating the attachment until it separates from the mop. To remove the steam jet nozzle, simply pull firmly.
Note: Do not turn the mop upside down to fit attachments. Putting pressure on the handle could damage it.
Using the utility head and upholstery cloth
To use the utility head and upholstery cloth, follow the instructions under the section titled "Using the Eco Mop" on page 7.
8