Air flow direction Fins (vertical vanes)
Press the IN FLAP button to let the fins turn left/right for an air flow direction that is comfortable to you.
Vanes
Press the OUT FLAP button to change the horizontal direction of the air flow, the
vanes take these positions in sequence: | . |
Usually the auto position works fine. |
|
Positions (1) and (2) are recommended for cool and | |
dehumidify mode. |
|
After one hour of operation in position | (4) or (5), the vane |
position will revert to level in order to prevent condensed water dropping down the vanes.
Manually handling of the vanes may cause damage, use the remote control.
Do not expose anybody to the cool air for a long period of time. This may discomfort the body which may be harmful to the health.
IMPORTANT
Auto restart
As a protective measure of the compressor, the air conditioner will automatic restart 3 minutes after electricity is restored following a power cut. If in doubt, check the settings.
Note: After shut down you have to wait 3 minutes before you can restart.
Range of internal thermostat
The internal thermostat can be set at a desired temperature between 64 °F (18 °C) and 86 °F (30 °C).
Note: whether the desired value is achieved depends on conditions in the room.
Capacity
The required cooling capacity depends greatly on the location and/or use of the room where the air conditioner is installed. Strong sunlight and the presence of people, lights or equipment create an additional heat load.
Normal living spaces require about 35 BTU per square feet of floor surface (~100 W/m2). In strong sunlight or if other sources of heat are present, this may be as much as 125 BTU/ft2.h (~350 W/m2).
Tip: on warm days, let the air conditioner cool the room as much as possible during the night. Cold walls and furniture will help to keep the room pleasant during use. Avoid strong sunlight.
8