NAME OF PARTS
Fig. 1 Indoor Unit
1Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3Remote Control Signal Receiver
4Indicator Lamps (Fig. 3)
5OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)
÷If the TIMER Indicator Lamp flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (See Page 17 Auto Restart).
7SWING Indicator Lamp (orange)
8Intake Grille (Fig. 4)
9 Air Filter
0 Air Flow Direction Louver -
(behind Air Flow Direction Louver) = Drain Hose
~ Inter
! Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
@Power Supply
# Intake Port $ Outlet Port % Pipe Unit
^ Drain port (bottom)
Fig. 6 Remote Control Unit 
&SLEEP button
*MASTER CONTROL button
(SET TEMP. /SET TIME button (
/
) ) Signal Transmitter
_ TIMER button
+ FAN CONTROL button ¡ START / STOP button
™ AIR FLOW DIRECTION button £ SWING LOUVER button
Rear side (Fig. 7)
¢TIME ADJUST button ∞ ACL button
(located inside battery compartment) § TEST RUN button
÷This button is used when installing the unit, and should not be used under normal conditions, as it will cause the air conditioner's thermostat function to operate incorrectly.
÷If this button is pressed during normal operation, the unit will switch to test operation mode, and the Indoor Unit's OPERATION Indicator Lamp and TIMER Indicator Lamp will begin to flash simultaneously.
÷To stop the test operation mode, press the START/STOP button to stop the air conditioner.
¶Remote Control Unit Display (Fig. 8)
• Transmit Indicator ª Clock Display
º Operating Mode Display
– Timer Mode Display ≠ Fan Speed Display
Ÿ Temperature Set Display ⁄ Timer Set Indicator
¤ Temperature Set Indicator