PREPARATION
Turn on the Power |
| |
| In the case of a direct line connection, turn on the circuit | |
| breaker. | ON |
Load Batteries (AAA x 2) |
| |
1 | Press and slide the battery compartment lid on the reverse | |
side to open it. |
| |
Slide in the direction of the arrow while pressing the 
mark.
2 Insert batteries.
Be sure to align the battery polarities (ª/·) correctly.
3 | Close the battery compartment lid. | ||
Set the Current Time |
| ||
1 | Press the TIME ADJUST button (Fig. 7 ¢). | ||
Use the tip of a | |||
2 | Use the | / | SET TEMP. SET TIME buttons (Fig. 6 () |
to adjust the clock to the current time. | |||
button: Press to advance the time. button: Press to reverse the time.
| (Each time the buttons are pressed, the time will be advanced/reversed |
| in |
| in |
3 | Press the TIME ADJUST button again. |
This completes the time setting and starts the clock. |
To Use the Remote Control Unit
÷The Remote Control Unit must be pointed at signal receiver (Fig. 1 3) to operate correctly.
÷Operating Range: About 7 meters.
÷When a signal is properly received by the air conditioner, a beep be heard.
÷If no beep is heard, press the Remote Control Unit button again.
Remote Control Unit Holder
Insert
Slide up 
Press in 
Screws | Pull out |
CAUTION!
÷Take care to prevent infants from accidentally swallowing batteries.
÷When not using the remote control unit for an extended period, remove the batteries to avoid possible leakage and damage to the unit.
÷If leaking battery fluid comes in contact with your skin, eyes, or mouth, immediately wash with copious amounts of water, and consult your physician.
÷Dead batteries should be removed quickly and disposed of properly, either by placing in a public battery collection receptacle, or by returning to appropriate authority.
÷Do not attempt to recharge dry batteries.
Never mix new and used batteries, or batteries of different types.
Batteries should last about one year under normal use. If the remote control unit’s operating range becomes appreciably reduced, replace the batteries and press the ACL button (Fig. 7 ∞) with the tip of a ballpoint pen or other small object.
1 Mount the Holder. | 2 Set the Remote Control | 3 To remove the Remote |
| Unit. | Control Unit. |