OPERATING INSTRUCTIONS:
Step 1. Set fan base on a dry, level surface.
Step 2. Plug cord into any standard 120 volt AC outlet. Please make sure the Speed Control Knob is in the Off position. This knob is located on the top of the Fan Motor Housing.
Step 3. The speed is adjusted by turning the control knob to the desired setting,
Step 4. The Oscillation Control Bar is located on the top of the Fan Motor Housing. To Start Oscillation, Push Bar Down. To Stop Oscillation, Pull Bar Up.
Special Note: This fan can be used in a
ADJUSTMENT INSTRUCTIONS:
Height Adjustment:
This fan is equipped with two poles which allow you to adjust the height of the fan for three height settings.
•Small Pole Only 30”
•Larger Pole Only 35”
•Both Poles for 50”
Fan Head Tilt Adjustment:
This fan is equipped with a
Step 1. To change the tilting angle of the fan head, simply loosen the Tilt Adjustment Knob (see figure # 3)
Step 2. Move the fan head to the desired angle, and firmly tighten the knob to lock in place.
Step 3. This fan can be tilted to a
Note: Whenever tilting the fan head, be sure to securely tighten in place.
CLEANING/MAINTENANCE INSTRUCTIONS:
Follow these instructions to correctly and safely care for your Holmes Products stand fan. Please remember:
•Always unplug the fan before cleaning or disassembling.
•Do not allow water to drip or enter the fan housing.
•Be sure to use a soft cloth moistened with mild soap solution.
•Do not use any of the following as a cleaner: gasoline, thinner, benzine.
Fan Blade Cleaning:
(See instructions for fan head assembly on page 2, figure #3)
STEP 1: To access the fan blade, remove the front grill and blade cap.
STEP 2: Clean the fan blade, front and rear grills with a soft, moist cloth.
STEP 3: Replace blade, tighten blade cap, and securely fasten the front grill.
Fan Head, Base, and Pole Cleaning:
Using a soft, moist cloth, with or without a mild, soap solution, carefully clean the fan base, pole, and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water.
FAN STORAGE:
Your fan can be stored in the
•If stored disassembled, we recommend using the original (or appropri- ately sized) box.
•If stored assembled or partially assembled, remember to protect the fan head from dust.
The exclusive Holmes Products FanBonnet is available to protect your fan. (See attached mail order form for special offer or call
FAN SERVICE INSTRUCTIONS:
1.Do NOT attempt to repair or adjust any electrical or mechanical func- tions on this unit. Doing so will void the warranty.
2.If you have any questions regarding this unit’s operation or believe any repair is necessary, please call
3.If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store where you purchased it. If you are return- ing the unit more than 30 days after the date of purchase, please see the enclosed warranty.
4.If you have any other questions or comments, feel free to write us at:
The Holmes Group P.O. Box 769
Milford, MA
DETACH FROM INSTRUCTIONS AND MAIL IN THIS FORM
EXTEND THE LIFE OF
YOUR FAN
For short term or seasonal storage of your Holmes fan
FAN
BONNET
$9.99
PLUS SHIPPING
AND HANDLING
Fill out form on reverse side or call
to place your order today.
Page 3