Speaker Setup
Speaker Configuration setup is important to perform prior to using the surround sound modes. It is possible to receive
How to change speaker configuration settings:
1.Press the SPEAKER SETUP button to choose speaker type. Each time you press the SPEAKER SETUP button, the speaker type changes as follows:
Subwoofer, Center Speaker, Rear speaker, Center Delay, Rear Delay.
2.Press the SELECT button change the settings for each speaker.
Subwoofer Output
SUB: ON
Choose if a subwoofer is used.
SUB:OFF
Choose if no subwoofer is used.
Front Speaker:
FRONT : LARGE
The mode to choose if a large speaker is installed. Front channels output is full range.
FRONT : SMALL
The mode to choose when using compact speakers. When using small compact front speakers, it is recommended to connect a powered subwoofer to play the LFE / Bass out channel.
Caution:
If the subwoofer selector is set to off, the LFE / Bass out frequencies are sent to the front speakers. This can cause damage to small compact speakers when played at high volume.
Center Speaker:
CENT : LARGE
Use this mode with a large center speaker.
CENT : SMALL
Use this mode with a small center speaker.
CENT : NONE
(DOLBY DIGITAL/DOLBY PRO LOGIC mode only): Use this mode if there is no center speaker.
The center channel signal will be divided between the Front L and R speakers.
Surround (Rear) Speaker:
REAR : SMALL
The mode to choose if small speakers are used.
Delay time can be chosen up to 30ms max.
36