GENERAL INFORMATION
The
Optional
Designed to mount at virtually any angle to guard or shield certain plastics, wiring or air filters that may be affected by UVC light.
SIZING AND SELECTING UNITS |
|
|
|
| Optional | ||
Square Footage |
| Volts | Watts | Amps | Hz | ||
(For ducts at least 16" wide) | |||||||
|
|
|
|
| |||
Up to 2000 |
| 1 | 120 | 30 | .5 | 60 | |
4000 |
| 2 | 120 | 30 | .5 | 60 | |
Notes: |
|
|
|
|
|
| |
• For applications with multiple systems, we |
|
|
|
| |||
recommend one unit per system. |
|
|
|
| |||
• For larger applications, multiple units are |
|
|
|
| |||
recommended. Contact technical support at |
|
|
|
| |||
|
|
|
|
| |||
INSTALLATION |
|
|
|
|
|
| |
1. Locate a suitable location for the unit |
|
|
|
| |||
downstream from the 'A' coil in the supply |
|
|
|
| |||
plenum or in the return plenum; preferably |
|
|
|
| |||
downstream from the air filter. For optimum |
|
|
|
| |||
"cleaning" effect on the 'A' coil, mount the |
|
|
|
| |||
unit in the supply plenum as close as possible |
|
|
|
| |||
to the 'A' coil. (See Figure 1) |
|
|
|
| |||
CAUTION: Investigate and determine the |
|
|
| Figure 1 | |||
location of the A coil prior to drilling holes in duct for mounting |
|
| |||||
unit. |
|
|
|
|
|
| |
NOTE: For duct board installation, refer to enclosed bagged |
|
| |||||
assembly containing mounting plate and instructions. |
|
|
| ||||
2. Apply supplied mounting template to air duct in either a vertical |
|
| |||||
or horizontal position as shown in Figure 2. (Leave template |
|
| |||||
mounted to duct for future reference.) |
|
|
|
| |||
3. Drill 1⁄8" diameter mounting holes at positions indicated on |
|
| |||||
template. (See Figure 3) |
|
|
|
|
| ||
1 Richard Riley, M.D. “Airborne Infection: The American Journal of Medicine, |
|
Sept. 1974, Vol. 57 - 5/16/01 | Figure 2 |
WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the
page 3