Empire Products DV-25T-1, DV-35T-1 installation instructions Installation Instructions

Page 1

INSTALLATION INSTRUCTIONS

AND

OWNER'S MANUAL

DIRECT VENT

WALL FURNACE

MODELS

DV-25T-1

DV-35T-1

Installer: Leave this manual with the appli- ance.

Consumer:Retain this manual for future refer- ence.

WARNING: If the information in these instruc- tions are not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

Do not store or use gasoline or other flamma- ble vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas suppli- er’s instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

Thisappliancemaybeinstalledinanaftermarket, permanentlylocated,manufacturedhome(USA only) or mobile home, where not prohibited by state or local codes.

This appliance is only foruse with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases, unless a certified kit is used.

WARNING: If not installed, operated and maintained in accordance with the manufacturer's instructions, this product could expose you to substances in fuel or from fuel combustion which can cause death or serious illness.

Page 1

Image 1
Contents Installation Instructions Table of Contents Vent KIT Information Important Safety InformationLP-GAS Warning Odor Safety Information for Users of LP-GASClear of ALL Obstructions Requirements for MassachusettsIntroduction SpecificationsMethod of Installing a Tee Fitting Sediment Trap Installing a New Main Gas CockGAS Supply Locating Gas SupplyClearances Installation InstructionsLocation of Furnace Locating Wall OpeningOn Sheet Rock Wall Using Plastic Expansion Anchors Installing Wall Mounting BracketAttaching Furnace to Wall Mounting Bracket Reassembly And Resealing Vent-Air Intake System Installing Vent AssemblySystem Check Figure Thermostat LocationPiezo Pilot Ignitor Instructions Lighting Instructions For Your Safety Read Before LightingMain Burner Flame Characteristics Pilot Flame CharacteristicsPrimary Air Adjustment Figure Troubleshooting MaintenanceParts List HOW to Order Repair PartsParts View Installing Optional DRB-1 Blower Optional Blower Installation InstructionsWiring Fan ControlOiling CleaningIndex Part Description 2090 Motor Service Notes