Important Safety Information

THIS IS A HEATING APPLIANCE

DO NOT OPERATE THIS APPLIANCE WITHOUT FRONT PANEL INSTALLED.

•Due to high temperatures the appliance should be located out of trafﬁc and away from furniture and draperies.

•Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition.

•Young children should be carefully supervised when they are in the same room as the appliance.

•Clothing orotherﬂammable material should not be placed on or near the appliance.

•Any safety screen or guard removed for servicing an appliance must be replaced prior to operating the ap- pliance.

•Keep burner and control compartment clean.

•Vent cap hot while furnace is in operation.

•Installation and repair should be done by a QUALIFIED SERVICE PERSON. The appliance should be inspected before use and at least annually by a qualiﬁed service person. More frequent cleaning may be required due to

excessive lint from carpeting, bedding materials, etc. It is imperative that control compartments, burners and circulating air passageways of the appliance be kept clean.

•DO NOT put anything around the furnace that will ob- struct the ﬂow of combustion and ventilation air.

•DO keep the appliance area clear and free from combus- tible material, gasoline and other ﬂammable vapors and liquids.

•DO examine venting system periodically and replace damaged parts.

•DO make a periodic visual check of pilot and burner. Clean and replace damaged parts.

•CAUTION: Pilot hole cover must be kept tightly closed during operation.

•DO NOT use this heater if any part has been under water. Immediately call a qualiﬁed service technician to inspect the heater and to replace any part of the control system and any gas control which has been under water.

VENT KIT INFORMATION

Attention: The DV-25T and DV-35T direct vent wall furnaces are provided with vent kit, DV4T-59-1 for wall depths of 5" to 9". For wall depths greater than 9", refer to Accessories, Page 6. Listed below are the vent kits.

Attention: The minimum wall depth for installation of a DV-25T or DV35T MUST BE 5". If the wall depth is less than 5" you can order DV-822, refer to Accessories, Page 6 or refer to Figure 7 and Figure 8 with accompanying text, Page 10.

Vents Kits

No.	Part	DV4T-59-1	DV4T-812-1	DV4T-1219-1
1	Outlet Tube - Inner	13057	13057	13058
2	Gasket - Outer Collar	M-177	M-177	M-177
3	Outlet Tube - Inner	13104	13104	13105
4	Inlet Tube - Inner	13062	13062	13063
5	Gasket - Inlet Collar	M-178	M-178	M-178
6	Inlet Tube - Inner	13106	13106	13107

7	Inlet Tube - Outer	13064	13065	13066

8	Outlet Tube - Outer	13059	13060	13061

9	Vent Cap	13053	13053	13053

	Hardware Kit	13078	13078	13078

13117-9-0907

Page 3