Carrier instruction manual Book Catalog No Form 58CMA-4SI Replaces 58CMA-3SI Tab

Page 12

4.Remove cover from control box and disconnect thermostat and power wires from the board.

5.Slide blower forward on rails toward front of unit.

6.Reverse items 1 through 5 to re-install blower. Refer to wiring diagram (Fig. 3 or 4) of these instructions or diagram located on inside of blower door to properly rewire unit.

Copyright 2003 CARRIER Corp. • 7310 W. Morris St. • Indianapolis, IN 46231

58cma4si

 

 

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.

Book

1

4

PC 101

Catalog No. 535–80076

Printed in U.S.A.

Form 58CMA-4SI

Pg 12

9-03

Replaces: 58CMA-3SI

 

Tab

6a

8a

 

 

 

 

 

 

 

Image 12
Contents Table of Contents Safety ConsiderationsDimensions IntroductionUnit Size ANSI/NFPAInstallation Minimum Clearances To Combustible MaterialsLocation Minimum Floor Area For Unconfined Space Combustion Air From Confined SpaceUnconfined Space Confined SpaceCombustion Air From Unconfined Space Combustion Air From Outdoors Through Vertical DuctsCombustion Air From Outdoors Through Horizontal Ducts Electrical Data OIL BurnerOIL Connections Barometric Draft ControlSTART-UP, ADJUSTMENT, and Safety Checkout Filter and FlangeFurnace Draft Conditions In. WC Operational CheckoutWiring Diagram X04032 Rev. a → -Burner Input and Nozzle Size at 100 psi Pump Pressure Speed SelectionMaintenance Airflow Data CFMOil Burner Heat Exchanger and Flue PipeBook Catalog No Form 58CMA-4SI Replaces 58CMA-3SI Tab