Lennox Hearth CI1500DVF Maintenance Schedule, Maintenance Task Accomplishing Person Procedure

Page 5

MAINTENANCE SCHEDULE

Anually (Before the onset of the Burning Season)

Maintenance Task

 

Accomplishing Person

Procedure

 

 

 

 

Inspecting/Cleaning Burner, Logs

 

Qualified Service Technician

Inspect valve and ensure it is properly operating. Check piping

and Controls

 

 

for leaks. Vacuum the control compartment, fireplace logs and

 

 

 

burner area.

 

 

 

 

Check Flame Patterns and Flame

 

Qualified Service Technician

Refer to Figure 7 on Page 6 and verify the flame pattern and

Height

 

 

height displayed by the appliance conforms to the picture. Flames

 

 

 

must not impinge on the logs. Ensure flames are steady (not

 

 

 

lifting or floating).

 

 

 

 

Inspecting/Cleaning Pilot and Burner

 

Qualified Service Technician

Refer to Figure 7 (Page 6) and Figure 18 (Page 9). Remove

 

 

 

any surface build-up on pilot and burner assembly. Wipe the

 

 

 

pilot nozzles, igniter/flame rod and hood. Ensure the pilot flame

 

 

 

engulfs the flame sensor as shown.

 

 

 

 

Checking Vent System

 

Qualified Service Technician

Inspect the vent system at the top and at the base (within the

 

 

 

firebox) for signs of blockage or obstruction. Look for any signs

 

 

 

of dislocation or deterioration of the vent components. Note:

 

 

 

Excessive condensation can cause corrosion of caps, pipe &

 

 

 

fittings (excessive condensation can be caused by long lateral

 

 

 

runs, too many elbows and/or exterior portions of the system

 

 

 

being exposed to cold weather). Also inspect wall straps or

 

 

 

plumbers's tabe to ensure it is secure and in place.

 

 

 

 

Appliance Checkout

 

Qualified Service Technician

Perform the appropriate appliance checkout procedure detailed

 

 

 

in this manual.

 

 

 

 

Replacing Rockwool Ember Materials

 

Homeowner/Qualified Service

Remove old ember materials and vacuum the rockwool place-

 

 

Technician

ment area. Place new rockwool as described on Page 9 (see

 

 

 

Figure 18).

 

 

 

 

Periodically (After the Burning Season)

 

 

 

 

 

 

Maintenance Task

 

Accomplishing Person

Procedure

 

 

 

 

Cleaning Firebox Interior

 

Homeowner

Carefully remove logs, rockwool, volcanic stone and vermiculite.

 

 

 

Vacuum out interior of the firebox. Clean firebox walls and log

 

 

 

grate. Replace logs, Rockwool and volcanic stone as detailed

 

 

 

in this manual.

 

 

 

 

Check Flame Patterns and Flame

 

Homeowner

Refer to Figure 7 on Page 6 and verify the flame pattern and

Height

 

 

height displayed by the appliance conforms to the picture. Flames

 

 

 

must not impinge on the logs.

 

 

 

 

Checking Vent System

 

Homeowner

Inspect the vent system at the top and at the base (within the

 

 

 

firebox) for signs of blockage or obstruction. Look for any signs

 

 

 

of dislocation of the vent components.

 

 

 

 

Cleaning Front Glass Enclosure Panel

 

Homeowner

Clean as necessary following the directions provided in this

 

 

 

manual. DO NOT TOUCH OR ATTEMPT TO CLEAN GLASS

 

 

 

WHILE HOT.

 

 

 

 

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

5

Image 5
Contents Pour Réduire AU Minimum LE Risque D’INCENDIE Table of Contents Lower Access Door Control Compartment AccessTables 3 and 4 show the units gas pressure requirements Operation and Care of Your ApplianceGlass Cleaning MaintenanceVerify Proper Operation After Servicing Models with Porcelain Enamel FinishMaintenance Task Accomplishing Person Procedure Maintenance ScheduleBurner Adjustments Front Glass Enclosure Panel, Removal and InstallationReinstall Trivet Burner Flame AppearanceAir Shutter Adjustment Guidelines Burner Air Shutter AdjustmentLeft Top Twig Log PlacementRear Log Stoppers SIT Millivolt Appliance Checkout Do not Place Embers on TOP of the Burner SlotsProper Pilot Flame Appearance Small Area Paint Touch-upWarranty Information Wiring DiagramsReplacement Parts Product Reference InformationAccessory Components Warming Shelves Brickaded Liner KitsThis appliance has a pilot which must be lighted with a To Turn OFF GAS to ApplianceSIT Millivolt Gas Valve To PilotPour Fermer LE GAZ QUI Alimente L’APPAREIL Instructions DallumageSymptom Possible Causes Corrective Action Gas Controls Replacement Parts ListCast Body Components Room Air Blower System Optional Kit 2021 29b 1314425 Optional Warming Shelves Kit Reference Information