8
Log Placement
WARNING: LOGS GET VERY HOT AND WILL REMAIN HOT UP TO ONE HOUR AFTER GAS SUPPLY IS TURNED OFF. HANDLE ONLY WHEN LOGS ARE COOL. TURN OFF ALL ELECTRICITY TO THE APPLIANCE BEFORE YOU INSTALL LOGS.
WARNING: THIS APPLIANCE IS NOT MEANT TO BURN WOOD. ANY ATTEMPT TO DO SO COULD CAUSE IRREPA- RABLE DAMAGE TO YOUR APPLIANCE AND PROVE HAZARDOUS TO YOUR SAFETY.
WARNING: THE SIZE AND POSITION ON THE LOG SET WAS ENGINEERED TO GIVE YOUR APPLIANCE A SAFE, RELIABLE AND ATTRACTIVE FLAME PATTERN. ANY ATTEMPT TO USE A DIFFERENT LOG SET IN THE STOVE WILL VOID THE WARRANTY AND WILL RESULT IN INCOMPLETE COMBUSTION, SOOTING, AND POOR FLAME QUALITY.
WARNING: IF LOGS ARE NOT INSTALLED ACCORDING TO THE DIRECTIONS SHOWN HERE, FLAME IMPINGEMENT AND IMPROPER COMBUSTION COULD OCCUR AND RESULT IN SOOT AND/OR EXCESSIVE PRODUCTION OF CARBON MONOXIDE (CO), A COLORLESS, ODOR- LESS, TOXIC GAS.
Carefully install this
1.Place the ember strip in front of the burner as shown in Figure 9. It should be positioned all the way back (toward the
Rear Log Stoppers
Ember
Strip
Figure 9
2.Place the largest log onto the rear log stoppers (see Figure 9). Ensure that the grooves on the bottom of the log aligns onto the corresponding places on the rear log stoppers. Push the log back so that it is against the back of the rear log stoppers (see Figure 10).
Rear
Log
Figure 10
3.Place the left front log onto the corre- sponding burner pin and
Left Front Log
Figure 11
4. Place the center log piece over the cor- responding pins next to the front left log as shown in figure 12.
Center
Log
Piece
Figure 12
5.Install the right front log onto the cor- responding burner pin and
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Right Front Log
Figure 13
6.Install the left top twig onto the correspond- ing pin on the rear log and align it with the indentation on the front left log as shown in figure 14.
Left Top
Twig
Figure 14
7. Install the center top twig onto the cor- responding pin on the rear log and align it with the indentation on front left log as shown in figure 15.
Center
Top Twig
Figure 15
8.Install the front right twig onto the cor- responding pin on the right front log. Align the twig with the indentation on the front right log as shown in figure 16.
Right
Front Twig
Figure 16