Weil-McLain PEG-30 THRU -65, EG-30 THRU -75 manual Damper installation

Page 12

EG-30 thru 75 Series 4 and PEG-30 thru 65 Series 4

Damper installation

Once damper is installed, boiler will not operate without a damper installed.

Only dampers listed in the Replacement parts table on page 24 are approved for use on EG and PEG Series 4 standing pilot boilers. Any other vent damper installed could cause severe personal injury or death.

The following boiler models must have damper installed:

EG-30 thru EG-65, natural or propane gas.

PEG-30 thru PEG-65, steam, natural gas.

The following boiler models may have damper installed:

EG-75, natural or propane gas.

Figure 8  Vent damper assemblies

12

Part Number 550-110-032/0607

Image 12
Contents EG-30 thru PEG-30 thru Egpegegh Boiler manualPlease read this page first Hazard definitionsTable of contents EG-30 thru 75 Series 4 and PEG-30 thru 65 Series Control installation EG-30 thru -65 water boilers without tankless heatersEG-75 water boilers without tankless heaters EG-30 thru 75 Series 4 and PEG-30 thru 65 Series EG-30 thru -65 water boilers with tankless heaters EG-30 thru 75 Series 4 and PEG-30 thru 65 Series EG-75 steam boilers with probe-type low water cutoff EG-30 thru 75 Series 4 and PEG-30 thru 65 Series Mount and wire controls per wiring diagram, 10, and Figure EG-75 steam boilers with float-type low water cutoffDamper installation Following boiler models must have damper installedFollowing boiler models may have damper installed Installation Minimum clearances to combustiblesCheckout procedure Room thermostat anticipator settingsLighting instructions Robertshaw EG-30 thru 75 Series 4 and PEG-30 thru 65 Series Standing Pilot Boilers Control Supplement Lighting instructions Robertshaw 7000ERHC Troubleshooting Before troubleshootingEvent of vent damper failure Checking thermocouple or thermopile open system Figure Troubleshooting Troubleshooting Troubleshooting Replacement parts Part number