Honeywell 50100, 50300, 50200, 50150, 50250 Removing/Changing the Filters, To Reset Filter Indicator

Intelli-Check™Filter Indicator:

Models 50150, 50200, 50250, 50300 Series (continued)

When your Pre-filter Indicator Light turns on, it’s time to replace your pre-filter. It should be replaced at least every 3 months. If there are heavy concentrations of odors, smoke, or large particles in the home, you may need to change the carbon pre-filter more often. For instructions on how to replace your pre-filter, refer to section “Removing/Changing the Filters” in this manual.

Note: We do not recommend operating the air purifier without the carbon pre-filter.

Reset Filter Indicator/Turn Light Off:

Models 50150, 50200, 50250, 50300 Series

To Reset Filter Indicator

•Once the filter has been checked and cleaned or replaced as needed, the filter indicator will need to be reset.

•With the unit powered on, press and hold the appropriate filter indicator button down for approximately 10 seconds until the light turns off (Fig. 1).

Fig 1

I

II

III 0

HEPA FILTER

EFILTE	R
PR

Removing/Changing the Filters

CAUTION: DISCONNECT FROM POWER SUPPLY BEFORE SERVICING

Do not attempt to wash either the carbon pre-filter or the HEPA filter. They are not washable and washing will damage the filters.

The only two parts requiring any service are the carbon pre-filter and the HEPA filter. No tools are needed. To remove or change either filter, disassemble the unit as shown below:

Fig. 2

Fig. 3

Fig. 4

Step 1: Turn the air purifier off and unplug from the wall outlet.

Step 2: To open, gently place the air purifier on its side and unscrew the locking mechanism located on the bottom of the unit (Fig. 2).

Step 3: Remove the base assembly from the air purifier.

5