Kicker QS65.2, QS60.2 Configuring the QS for Coaxial Operation, Crossover Configuration

Step 1

Fig. 1

Configuring the QS for

Coaxial Operation

	coaxial mounting adapter
Steps 2–6	tweeter post	Step 7

tweeter lead wires

tweeter

Fig. 2

QS crossover

INPUT jumper.

Install only for 2-way confi gurations; do not install if bi-amping.

tweeter output-level jumpers.

One of these jumpers MUST be installed. Higher numbers mean more volume from the tweeter.

+3 dB

0 dB

CROSSOVER CONFIGURATION

The KICKER QS crossover can be confi gured as a conventional 2-way crossover by installing the included INPUT jumper into the - MID + -TW + input terminals as shown in Fig. 2. In this confi guration, the amplifi ed signal from your source unit or amplifi er should be wired to the + and - terminals indicated on the INPUT jumper.

The QS crossover can also be confi gured for bi-amp wiring by removing (or simply not installing) the INPUT jumper. To use the bi-amp confi guration, you must connect two amplifi ed signals to each crossover (you will need at least four amplifi er channels). Install one of the included tweeter output- level jumpers (0 dB, +3 dB, or +6 dB) to adjust the tweeter output level. Installing jumpers with higher numbers will result in more volume from the tweeter.

4 QSCOMPONENTSYSTEM

2009 QS Multilingual h01.indd 4

11/21/2008 10:54:27 AM