Honeywell 800-08091V3 manual Create a Room, Setting a Secondary Keypad Controller, Room Setup icon

Automation (cont'd)

Notes:

1.Motorized door lock bolts physically lock and unlock the door when activated, but if the door lock installed is a non-motorized type, activation allows the door to be manually unlocked without a key. See “Compatible Devices” section for further information.

2.Some thermostats do not update temperature status automatically (i.e., Wayne Dalton).

3.When using a Kwikset Smartcode Electronic Deadbolt door lock (in a Scene that is programmed to trigger when unlocked) the Scene does not trigger if using a key; enter a user code.

Create a Room

Multiple devices can function as a group by associating them in a “Room”. Follow the procedure below to create a Room.

ICON		ACTION		NOTES
	1. Press the Automation icon and then press the			Room names (i.e., All, etc.) are displayed across the top to the screen.
	Room Setup icon.			Enter the new device name by entering it on the data entry keyboard.
	2. Press the Add icon and enter a room name on the			• Use the Shift icon for capital letters.
	“Data Entry” keyboard.			• Use the BS (Backspace) icon to make corrections.
				The @#$ icon is not available for use at this time.
	3. Press OK.
	4. Highlight the device(s) from the list that you want			Use the Edit and Delete icon to rename, or delete a room.
	to add to this Room and press the Save icon.
Room Setup Icons
Delete	Edit	Add	Save

Setting a Secondary (Keypad) Controller

After all Z-Wave devices have been enrolled into the Primary (Keypad) Controller, the device information can be downloaded to a Secondary (Keypad) Controller. Keep the controllers within 10 feet of each other, apply power to the Secondary Controller and do the following:

ICON		ACTION	NOTES
	1. At the Primary Controller:		If used for Remote Services, Tuxedo should not be configured as
	a) Press the Automation icon from the “Home” screen		a secondary controller. See the Remote Services section.
		and then press the Z-Wave Setup icon to display the	Note: Up to 232 Secondary Controllers can be added.
		“Z-Wave Device Management” screen.	When the Primary Controller icon is pressed, the message is
			displayed:
	2. At the Secondary Controller:
			“Please remove all Z-wave devices from network first”
	a) Remove any Z-Wave devices that have been added.		The message is displayed: “Scanning for Devices”
	b)	Press the Z-Wave Primary icon (located in the lower	The message is displayed: “Updating Devices. Please Wait”.
	c)	right side of the screen).	When the device information from the Primary Controller is
		Select Yes to change this keypad to a Secondary	downloaded to the Secondary Controller:
		Controller.	• the Secondary Controller displays, “Controller Add Success”
	3. At the Primary Controller: Press Add.		• the Primary Controller displays, “Device Added Successfully”
	4. At the Secondary Controller: Press Add.

39