Whirlpool 188413 Operation Conditions, Anode Rod/Water Odor, Water Heater Sounds, Stacking

Page 11

Operation Conditions

Anode Rod/Water Odor

Each water heater contains at least one anode rod, which will slowly deplete while protecting the glass-lined tank from corrosion and prolonging the life of the water heater. Certain water conditions will cause a reaction between this rod and the water. Once the anode is depleted, the tank will start to corrode, eventually developing a leak.

The most common complaint associated with the anode rod is a “rotten egg smell” produced from the presence of hydrogen sulfide gas dissolved in the water. Do not

remove this rod permanently as it will void any warranties, stated or implied.

The parts list includes a special anode that can be ordered if water odor or discoloration occurs. This rod may reduce but not eliminate water odor problems. The water supply system may require special filtration equipment from a water conditioning company to successfully eliminate all water odor problems.

Artificially softened water is exceedingly corrosive because the process substitutes sodium ions for magnesium and calcium ions. The use of a water softener may decrease the life of the water heater tank.

The anode rod should be removed from the water heater tank every 3 years for inspection. If the rod is more than 50% depleted, the anode rod should be replaced. (See “Replacing the Anode Rod” in the maintenance section.)

Water Heater Sounds

During the normal operation of the water heater, sounds or noises may be heard. These noises are common and may result from the following:

1.Normal expansion and contraction of metal parts during periods of heat-up and cool-down.

2.Sediment buildup in the tank bottom will create varying amounts of noise and may cause premature tank failure. Drain and flush the tank as directed under “Draining and Flushing”.

Stacking

Stacking occurs when a series of short draws of hot water (3 gallons or less) are taken from the water heater tank. This causes increased cycling of the heater elements and can result in increased water temperatures at the hot water outlet. An anti-scald device is recommended in the hot water supply line to reduce the risk of scald injury.

11

Image 11
Contents Energy Smart Residential Electric Water Heater Your safety and the safety of others are very important Important Safety InstructionsUnpacking the Water Heater Installing Your Water HeaterConsumer Information Consumer ResponsibilitiesSite location Location RequirementsWater System Piping Piping InstallationClosed System/Thermal Expansion Temperature and Pressure Relief ValveDischarge Line Solar InstallationTemperature & Pressure Relief Valve Electrical RequirementsWater System Piping Installation ChecklistWiring Diagram Volts Only Water Heater LocationWater Heater Start-Up Water Temperature RegulationSafety Shut-off Operating Your Water HeaterDiagnostic Indicator Light Analysis Operating the Temperature Control SystemWater Temperature Adjustment Operating Mode DescriptionsStacking Operation ConditionsAnode Rod/Water Odor Water Heater SoundsReplacing the Anode Rod Maintenance of Your Water HeaterTemperature and Pressure Relief Valve Draining and FlushingHeating Element Replacement Troubleshooting Chart Diagnostic Code ChartRepair Parts Repair Parts Illustration