Whirlpool 188414, EE2H40RD045V, 188413, 188410, 188412 Location Requirements, Site location

Page 4

Location Requirements

Site location

Select a location near the center of the water piping system. It must be installed indoors and in a vertical position on a level surface.

The water heater should be located in an area not subject to freezing temperatures. Water heaters located in unconditioned spaces (i.e., attics, basements, etc.) may require the water piping and drain piping to be insulated to protect against freezing. The drain and controls must be easily accessible for operation and service.

Do not use this water heater in conjunction with a spa or hot tub.

Note: Local codes and requirements in your area may require the water heater to be installed such that the bottom element is elevated from the floor at least 18 inches.

Important: The water heater should be located in an area where leakage of the tank or connections will not result in damage to the area adjacent to the water heater or to lower floors of the structure. Due to the normal corrosive action of the water, the tank will eventually leak after an extended period of time. Also any external plumbing leak, including those from improper installation, may cause early failure of the water tank due to corrosion if not repaired. If the homeowner is uncomfortable with making the repair a qualified service technician should be contacted. It is recommended that a suitable drain pan be installed under the water heater as shown below. This pan is to protect the property from damage which may occur from normal condensate formation on the tank or leaks in the tank and pipe connections. The pan must limit the water level to a maximum depth of 2-1/2 inches and be two inches wider than the heater and piped to an adequate drain. Locate the water heater near a suitable indoor drain. Outdoor drains are subject to freezing temperatures which can obstruct the drain line. The piping should be at least 3/4”ID and pitched for proper drainage.

Under no circumstance will the manufacturer or seller of this water heater be held liable for any water damage is caused by your failure to follow these instructions.

2 1/2” Max

Pipe to

adequate

drain

At least 2” inches greater than the diameter of the water heater.

Note: The water heater shall be located so it is not subject to physical damage by moving vehicles or area flooding.

Figure 1

Residential Garage

Installation

Vehicle

Stop

Drain

Drain

Pan

 

State of California

Note: The water heater must be braced, anchored, or strapped to avoid moving during an earthquake. Contact local utilities for code requirements in your area or call 1-877-817-6750and request instructions.

4

Image 4
Contents Energy Smart Residential Electric Water Heater Important Safety Instructions Your safety and the safety of others are very importantInstalling Your Water Heater Consumer InformationConsumer Responsibilities Unpacking the Water HeaterLocation Requirements Site locationPiping Installation Water System PipingTemperature and Pressure Relief Valve Closed System/Thermal ExpansionSolar Installation Temperature & Pressure Relief ValveElectrical Requirements Discharge LineInstallation Checklist Wiring Diagram Volts OnlyWater Heater Location Water System PipingWater Temperature Regulation Safety Shut-offOperating Your Water Heater Water Heater Start-UpOperating the Temperature Control System Water Temperature AdjustmentOperating Mode Descriptions Diagnostic Indicator Light AnalysisOperation Conditions Anode Rod/Water OdorWater Heater Sounds StackingMaintenance of Your Water Heater Temperature and Pressure Relief ValveDraining and Flushing Replacing the Anode RodHeating Element Replacement Diagnostic Code Chart Troubleshooting ChartRepair Parts Illustration Repair Parts