To Part Set the System
+ | For Part Set 1 |
or
+
For Part Set 2
or
+
For Part Set 3
Then retire to an unprotected area 
Note: Your engineer may have programmed the Part Set exit sounders as silent. If so a single beep will be given when the exit time expires.
Unsetting the System
Your installation engineer will have defined to you what route you should take when entering the premises with the system set. To avoid false alarms you must always take this route.
To Unset the System
Enter
Note: If an alarm has occurred when the system was set all LEDs will be flashing when you unset the system. Pressing the No key will display the cause of the alarm for 3 seconds. Please refer to the Resetting After An Alarm section for reset details.