AmeriGlide GARDTEC 350+ manual Power LED, Part Setting the System

Page 4

Power LED

The Power LED gives an indication of that the mains supply to the unit is good. It should be illuminated at all times except when User Programming mode is being used. Please refer to User Programming Mode section for more details.

Setting the System

When you set the system fully all zones are active after the setting delay has expired.

ExitWait

After exiting and securing the premises always wait until the exit sounders have stopped before leaving.

To Abort Setting During Exit Time

Part Setting the System

Your installation engineer may have programmed up to two part sets for your system, these part sets are defined below.

Part 1

A group of system zones that will be removed (turned off)

 

when Part 1 set is used. Some or all of these zones may also

 

be contained within Part 2.

Part 2

A group of system zones that will be removed (turned off)

 

when Part 2 set is used. Some or all of these zones may also

 

be contained within Part 1.

A third part set is also available as defined below.

Part 3

All system zones that are programmed as Part 1 and Part 2

 

will be removed (turned off) when Part 3 set is used.

Your installation engineer will provide you with information about system zones that are programmed as part set zones (if any).

Image 4
Contents Gardtec 350+ Quick Start User Guide Introduction Caring for your SystemTampers & PAs Unset & Set Display StatusSetting the System Power LEDPart Setting the System Unsetting the System Resetting After An Alarm User Programming Mode RemoveRemoving Individual Zones ChimeTesting The System Page Viewing The Log To escape from the Log Mode Turning Chime On/Off Programming User Codes User Numbers 3Programming User Codes Display will show New Code Again Display will show