DVR4C Remote Viewer Operation Manual Configuration Tool
EN 12
5.2.1Information tab
The Information tab shows basic information about the DVR.
5.2.2Camera
Use this tab to set the video gain, brightness, and contrast for the cameras connected to the DVR.
5.2.3Recording
Use this tab to set the Normal Recording and Event Recording parameters.
5.2.4Event setup
Set the configuration of alarm inputs and the motion detection in this tab.
5.2.5Profiles
Use this tab to set the applicable periods for Weekday / Weekend and day / night. Up to 30 exception days can be configured.
5.2.6System Settings
Use this tab to configure the various system settings.
5.2.7Connectivity
Use this tab to set the DVR's network information; Ethernet IP address, xDSL, PSTN and port settings.
>For more information, refer to the Network settings menu of the DVR4C manual.
5.2.8Disk manager
Disk setup
•When the Recording mode is set to Continuous (default), the DVR overwrites older images when the hard disk is full. When set to Linear, the DVR stops recording when the hard disk is full and the administrator has to delete video manually.
•Set a disk full warning percentage from 1 to 100% (default 95%). A warning message is generated when the used disk space exceeds the percentage set.
Block playback
•To block the playback of video that is older than a certain time, select a period from the
5.2.9 Security tab
Use this tab to control access to the DVR. If you select IP filtering, you can set up to ten IP address ranges that are allowed or denied access to the DVR. The values you set will normally depend on your network setup.
The IP address can be within a range from 000.000.000.000 to 255.255.255.255.