Aiphone IME-100, Iai-100, IME-150, ISE-100 Outer microphone/speaker English, Options English

4-12
1		2
		to Main unit
[1]		(-) White
		(E) Shield
		(+) Red
[2]		from
		External mic.
3		4
		to Main unit
	[3]	(+) Black
		(-) White
		from
		External speaker

Outer microphone/speaker English

[1]Raceway

[2]Optional microphone

[3]Outer speaker

1.Attach the optional microphone with double-sided tape along the architectural sash. Clean the surface before attaching. Use a strong industrial double-sided tape that can attach aluminum and glass.

•Examine the wiring route in advance and determine the best layout. The appropriate position is at the height of the customer's head, and approximately 300mm to 400mm (12-16") to the right or left.

2.Splice the 2-conductor shielded cable from the optional microphone with the 2-conductor shielded cable from the main unit.

3.The outer speaker is purchased separately. For installation, follow the instructions provided with your speaker.

•The speaker should be above the customer's head. Select a suitable wiring route and determine the installation position.

4.Splice the cable from the outer speaker with the cable from the main unit.

1. Insulate the spliced wires.

2. Lay out the wires within the sash, or use a raceway.

3. Be sure to splice the cables with the correct polarity. 4. The optional microphone is not weather resistant.

4-13

1[2]

[1]

2[2]

[3]

Volume

Options English

[1]Paging speaker

[2]Terminal block

[3]Sensor ISE-100

1.Use the instructions provided with the product when installing the paging speakers. There are many types of speakers available, such as wall speakers, ceiling speakers and horn speakers. Select the type most suitable for your paging

broadcast area and your needs. Impedance: 4 to 8 Ω

Rated input: 3 W or more

Maximum input: 6 W or more

Be sure not to short the speaker cable and the power supply cable (24V), as it could cause a speaker malfunction.

2.Install the sensor under the counter on the customer side or on the upper section of the wall with the 2 screws provided. There are screw holes in the handle of the sensor. Insert the sensor output cable (2- conductor shielded cable) into the STBY [+ SW -] terminal of the main unit terminal block, making sure that the polarity is correct.

1. Install the sensor in a position where the customer will be sure to enter the detection area: approximately 2m, 6'6".

2. The initial sensitivity setting for the sensor is maximum. Turn the sensitivity volume knob counterclockwise to reduce the sensitivity. The sensor is operating if the LED (green) on the sensor main unit display is illuminated. After an object stops being detected, it takes about 10 seconds for the sensor to turn off.

3. If the lens of the sensor is dirty or dusty it could interfere with operation. It is also possible that children may play around with the sensor. Take preventative measures as necessary.

NOTES: The STBY [SW –] in the main unit terminal block can be used as a communication "normally open" input terminal. If the switch is in the closed position, the operation is the same as if the TALK button were pushed. Use the method most suitable for your needs. Rated voltage: DC 30 V

Rated current: 15 mA

Contact resistance: 100 Ω or less

Cable layout length: Maximum 20m,65'(Ø0.65 mm (22AWG) to 1.2 mm (16AWG))

For details, please contact your local distributor.

- 13 -