3Com TECHD-0000000122 manual Safety Requirements

Page 29

Safety Requirements

WARNING: Only trained and qualified personnel should install, replace, or service this equipment. Disconnect the system before servicing.

Read all of the installation instructions before you connect the system to its power source.

Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

The TippingPoint X506 uses double pole/neutral fusing. Use caution when servicing this product.

For protection against fire on the TippingPoint X506, use replacement fuses with the following type and rating only: 5x20 mm, 2a, 250 volts, fast acting.

Do not operate the system unless all faceplates and covers are in place. Faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI) that could disrupt other equipment; and they direct the flow of cooling air through the chassis.

To prevent personal injury or damage to the chassis, lift the chassis from underneath its lower edge.

Enclosed racks may have higher ambient temperatures than open racks. Ensure enclosed racks ambient temperatures do not exceed maximum recommended ambient temperature of 104 °F (40 °C).

X-Series Hardware Installation and Safety Guide V 2.5

11

Image 29
Contents Version Series Installation Safety GuideCopyright 2006 3Com Corporation. All rights reserved Table of Contents TippingPoint X505 Overview Prepare the SiteIndex Page Front Panel List of FiguresPage List of Tables List of Tables Target Audience About This GuideOverview About the Guide OrganizationHeadings ConventionsTypeface Cross ReferencesTip Tmc.tippingpoint.com Related DocumentationSecurity Management System Online Help Table About 1 TippingPoint DocumentsTable About 2 Customer Support Information Location Customer SupportContact Information Xvi TippingPoint X-Series Overview OverviewCore Functionality TippingPoint X-Series EnvironmentPolicy Enforcement Optimized VPN ConnectivitySecurity Zones and Network Interfaces TippingPoint IPSLocal Security Manager Threat Suppression EngineSeries System Performance Model Ethernet Concurrent Firewall Triple DES Interfaces Sessions PerformanceThreat Management Center Security Management SystemOverview Series Hardware Installation and Safety Guide V Prepare the Site Class a Notices Safety RequirementsGeneral Guidelines Prepare the Site Safety Requirements Ventilation and Location Rack and Clearance RequirementsEnvironmental Requirements Reliable EarthingTo unpack the TippingPoint X-Series system Unpack the TippingPoint SystemPage TippingPoint X505 Overview Chassis Overview Chassis FeaturesPort USB PortLED Descriptions LEDsColor State Description Management Port LED DescriptionsTippingPoint X-Series X505 Specifications Description Technical SpecificationsHardware Specifications Software Specifications Hardware Installation and ConfigurationTechnical Specifications Min/Max Number of Chassis Install the TippingPoint ChassisRack Space Requirements Complete Initial Setup Configuration Connect the powerRegister the TippingPoint Connect the X505 to the InternetTippingPoint X506 Overview Port Status LEDs Port PortSegment Port LED Descriptions TippingPoint X-Series X506 Specifications DescriptionTippingPoint X506 Hardware Specifications Detail Description Or = 42 RUs. Each TippingPoint X-Series X506 requires 1RU Connect the power Connect the X506 to the Internet Register the TippingPoint Figure a 1 RJ-45 Connector Port ConnectorsTable a 3 DB-9 Connector Pinouts Pin Number Signal Name DB-9 Connector PinoutPort Connectors Page Index Index Series Hardware Installation and Safety Guide V