SVAT ELECTRONICS
now you can see
Powering On
1.The power adapter comes in two pieces. Assemble the power adapter by plugging the power cord into the power brick, as shown on the diagram on the previous page. Plug the three pronged power cord into a power outlet. (It is strongly recommended to use a surge protected power bar and Uninterrupted Power Supply (UPS) backup. This will prevent
power surges or outages which may cause damage to the DVR or hard drive.) Plug the opposite end of the cord into the DC IN port on the back of the DVR. (Please refer to the diagram on the opposite page)
2.To turn the DVR on and off, use the power switch on your UPS or power bar. This DVR does not have a power switch. This is for your security and helps to prevent other people from accidentally or intentionally turning the DVR off.
3.The DVR will power on and you will see a boot screen. After the DVR initializes, your cameras should be displayed and recording will begin immediately. If you want the DVR to record continuously (24hr recording), no further setup is required. However, you may wish to adjust the system time if it is incorrect (see page 11 System Setup>Time Setup for more details).
Note: If a video signal is not detected on one or more camera channels (VIDEO LOSS), the system will sound an alarm (by default). Press any button to stop the alarm. If video loss occurs on one of your camera channels during recording, the DVR will continue to record. However, if all four camera channels experience video loss, the DVR will stop recording.
DVR OPERATION
Basic Operation
1.The DVR will automatically display all four camera views in Quad Screen. To view each camera individually, use the ▲/1,◄/2, ▼/3, ►/4 buttons to view cameras
2. | To stop or start recording, press the | button. |
3. | While recording, you must press the | button first before playing back footage or entering the |
| setup menu. |
|
4.While in live view (not recording), press the
5.While in live view (not recording), press the
button to enter playback mode.
button to enter the setup menu. If the DVR password is |
enabled, a password screen will appear. Use the channel buttons
CLEARVU2 | 8 |