TROUBLESHOOTING GUIDE
My DVR has no power | • | Check the power cord connection to the DVR and the outlet and ensure that the DVR has power |
|
|
|
There is no way to turn the DVR off | • | The DVR is set to run as long as it is plugged in, if you would like to turn it off you have to |
|
| unplug it |
|
|
|
I cannot hear recorded audio when | • | Are audio equipped cameras being used? Please note that audio equipped cameras are not |
playing back |
| included with this DVR system |
| • | Make sure that the audio cable is properly connected and inserted in the Audio IN and that the |
|
| other end is plugged into a microphone or audio supported camera. Please note that only one |
|
| channel can record audio |
| • | Make sure the volume is turned up on your speaker/amp |
Playback video is choppy | • | Check the FPS (Frames Per Second) rate for each camera that is recording choppy video. |
|
| Refer to your settings in the Record Menu. Cameras with a higher FPS (30 is the highest) will |
|
| record more fluid video than cameras set to a lower FPS. For more information on making |
|
| changes to the Record Menu, see Pg. 63 |
|
|
|
Timer recording is not working | • | Check to see if you have the proper time set on your DVR. Refer to the instruction manual under |
properly |
| Time Setup |
| • | Double check your schedule record times – you may have it set on the no record function |
|
|
|
My PTZ camera (not included) is not | • | Verify the channel, protocol, and baud rate with the PTZ camera’s instruction manual or the |
working. The picture is displaying, |
| manufacturer of the camera |
but I cannot control the camera | • | Verify the PTZ camera is connected to the proper PTZ inputs |
|
|
|
I have lost video footage | • | This could be from lost footage due to tampering of cameras, make sure to check all |
|
| connections are secure and set properly |
| • | The hard drive overwrite may be disabled, this will make the recording stop when the hard |
|
| drive is full. To change this go to the Hard Drive set up and turn Overwrite Enabled on |
I plugged a mouse into the USB | • | The CV501 - 16CH’s mouse will only work when plugged into USB port on the right side |
port but it’s not working |
|
|
|
|
|
The Hard Drive is filling up too | • | Check your FPS that you are using, if you are using a high number of FPS then the hard drive |
quickly |
| will fill up faster. Try lowering your FPS for some cameras |
| • | Check the video quality you are using – If you are using a high video quality then the hard drive |
|
| will fill up quicker |
The camera’s image appears on | • | Check to see if the camera is in motion detection mode. If in motion detection move and there |
screen, but nothing is recorded |
| is no movement happening no footage will be recorded |
| • | If there is no symbols or icons in the in the top right corner, it means you have set your schedule |
|
| to have the camera cease recording |
|
|
|
Cannot view DVR remotely using | • | Try using a different port other then 80. Make sure you change this port on the DVR settings as |
port 80 |
| well as port forwarding settings |
| • | Try going to www.canyouseeme.org to find available open ports that you can adjust for |
|
| your DVR |
| • | View the Video Networking guides on www.svat.com |
CV501 - 16CH | 70 |
|
|