TOA Electronics VFST-CMN-2 dimensions Codes, Massachusetts And New York Require- ments

Page 3

Carbon Monoxide Poisoning: Early signs of carbon monoxide poisoning are similar to the flu with headaches, dizziness and/or nausea. If you have these signs, obtain fresh air im- mediately. Turn off the gas supply to the heater and have the Unvented Gas Heater serviced as it may not be operating correctly.

Due to high temperatures, the heater should be located out of traffic and away from furniture and draperies.

Children and adults should be alerted to the hazard of high surface temperatures and should stay away to avoid burns or clothing ignition.

Young children should be carefully supervised when they are in the same room with the heater.

Do not place clothing or other flammable material on or near the heater for the purpose of drying.

Installation and repair should be done by a qualified service person. The heater should be inspected before use and at least annually by a professionalserviceperson. More frequentclean- ing may be required due to excessive lint from carpeting, bedding material, etc. It is important that control compartments, burners and circulat- ing air passageways of the heater be kept clean.

Allow the heater to cool before servicing. Always shut off any electricity or gas to the heater while performing service work.

Do not install the VFST and VFPF series heaters in a bedroom or bathroom.

The installation must conform with local codes or, in the absence of local codes with the National Fuel Gas Code, ANSI Z223.1.

The heater and its individual shut-off valve must be disconnected from the gas supply piping system while performing any tests of the gas supply piping system at pressures in ex- cess of 1/2 psig.

Any safety screen or guard removed for servicing the heater must be replaced prior to operating the heater.

The heater must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure test- ing of the gas supply piping system at test pressures equal to or less than 1/2 psig.

Keep heater area clear and free from com- bustible materials, gasoline and other flam- mable vapors and liquids.

Do not use these appliances if any part has been under water. Immediately call a qualified professional service technician to inspect the appliance and to replace any parts of the control system and any gas control which have been under water.

Test gage connections are provided on the front of the gas control valve (identified A for the manifold side and E for inlet pressure).

Input ratings are shown in BTU per hour and are for elevations up to 7,000 feet. Operating heater above elevations of 7,000 feet may cause ODS pilot outage.

Ensure that the heater is clean when operat- ing. Excessive dust accumulation on the burner and logs will increase the amount of carbon monoxide formation and could lead to carbon monoxide poisoning and death.

CODES

Adhere to all local codes or in their absence the latest edition of The National Fuel Gas Code ANSI Z223.1 or NFPA54 which can be obtained from The American National Standards Insti- tute, Inc. (1430 Broadway, New York, NY, 10018) or National Fire Protection Association, Inc. (Batterymarch Park, Quincy, MA, 02269).

Massachusetts And New York Require- ments

These appliances are approved for installation in the following USA locations listed in the following:

Massachusetts:

These fireplaces are approved for installation in the US state of Massachusetts if the follow- ing additional requirements are met-

Installation and repair must be done by a plumber or gas fitter licensed in the Common- wealth of Massachusetts.

The flexible gas line connector used shall not exceed 36 inches (92 centimeters) in length.

The individual manual shut-off must be a T- handle type valve.

Vent-Free appliances may NOT be installed in bedrooms or bathrooms.

A working smoke detector must be installed in the area where vent-free appliances are installed.

Seller of unvented propane or natural gas- fired supplemental room heaters shall pro- vide to each purchaser a copy of 527 CMR 30 upon sale of the unit.

New York:

These fireplaces are approved for installation in the US state of New York, but not in New York city.

COMBUSTION AND VENTILATION AIR

These heaters shall not be installed in a con- fined space. The heater may be located in unusually tight construction provided the space is unconfined, or if confined, is pro- vided with two permanent openings commu- nicating directly with an additional room(s) of sufficient volume so that the combined volume of all connected spaces meets the criteria for an unconfined space, (National Fuel Gas Code ANSI Z223.1 (latest edition), Section 5.3). Generally 50 ft 3 per 1,000 BTU input of all operating appliances in the space.

The National Fuel Gas Code defines a con- fined space as a space whose volume is less than 50 ft 3 per 1,000 BTU/Hr (4.8 m3 per kw) of the aggregate input rating of all appliances installed in that space and an unconfined space as a space whose volume is not less than 50 ft 3 per 1,000 BTU/Hr (4.8 m3 per kw) of the aggregate input rating of all appliances installed in that space. Rooms communicat- ing directly with the space in which the appli- ances are installed, through openings not furnished with doors, are considered a part of the unconfined space.

Unusually tight construction is defined as con- struction where:

a. wall and ceilings exposed to the outside atmosphere have a continuous water vapor retarder with a rating or one perm or less with openings gasketed or sealed, and

b. weather stripping has been added on oper- able windows and doors, and

c. caulking or sealants are applied to areas such as joints around window and door frames, between sole plates and floors, between wall- ceiling joints, between wall panels, at penetra- tions for plumbing, electrical, and gas lines, and at other openings.

Use the following equations to determine if you have a confined or unconfined space.

1.Determine the volume of space — ft 3.

Length x Width x Height = _____ ft 3 (Include adjoining rooms with doorless pas- sageways or ventilation grills between rooms.)

Example: 16' (L) x 16' (W) x 8' (H) = 2048 ft 3

3

Image 3
Contents Unvented Decorative Gas Fireplaces 903571 REV. H 12/2007 Consumer Retain this manual for future referenceTable of Contents Massachusetts CodesMassachusetts And New York Require- ments Combustion and Ventilation AIRLocation of Fireplace ClearancesExample Check Gas Type PreinstallationAssembly Steps Installation StepsVfst Appliance Specifications Vfst Framing SpecificationsFraming Dimensions 22-3/4 578 mm 40-1/8 1016 mm Min43 1092 mm Min Gas Flex Line Kit, Model Gflv Finished Wall Details Vfst Series Standard Wiring DiagramFlame Appearance Assembling the LogsOptional Equipment Remote Control KitWall Switch Kit Installing the Optional Glass DoorWall Thermostat Kit Optional on Unit Rocker SwitchSolid Brass Hood Kit Solid Brass Louver KitOperation and Care of Your Appliance Cleaning and ServicingReplacement Parts Accessories and ComponentsKit Possible Cause Remedy Observed ProblemLighting Instructions For Your Safety Read Before LightingOperating Instructions What to do if YOU Smell GASTurn Control Knob to on Position Turn Control Knob to OFF Position PilotTurn Control Knob to Pilot Position Pilot LocationVfst Replacement Parts List VFST-CMNDescription Replacement Parts Vfst VFPF-CMN Vfpf Replacement Parts ListReplacement Parts Vfpf Page Page Orange, CA 903571 REV. H 12/2007

VFST-CMN-2 specifications

The TOA Electronics VFST-CMN-2 is a top-tier public address system speaker that epitomizes the fusion of technology and audio excellence. Renowned for its superior sound quality, this speaker is designed primarily for commercial, institutional, and outdoor environments. One of its standout features is its remarkable versatility, making it suitable for various applications, including schools, shopping centers, and outdoor events.

A key characteristic of the VFST-CMN-2 is its robust construction. Designed to withstand challenging conditions, the cabinet is made from high-impact ABS plastic, ensuring durability and longevity. This makes it an ideal choice for use in outdoor settings where exposure to the elements is a concern. Additionally, the speaker is equipped with a weather-resistant grille that helps protect the internal components from moisture and debris, further enhancing its suitability for external applications.

The VFST-CMN-2 also boasts an impressive frequency response, which allows it to deliver crystal-clear sound across a wide range of audio frequencies. Its ability to reproduce low, mid, and high frequencies ensures that announcements and music are clear and intelligible, making it an excellent choice for diverse audio needs. Complementing its sound capabilities, this speaker is equipped with high-efficiency drivers that maximize audio output while minimizing distortion.

Furthermore, the VFST-CMN-2 incorporates advanced technology that allows for easy installation and configuration. It features a dual voltage transformer that provides flexibility, enabling the speaker to operate at both 100V and 70V systems, catering to various installation requirements. The integrated mounting brackets make installation straightforward, allowing users to quickly position the speaker for optimal sound distribution.

The design of the VFST-CMN-2 also emphasizes aesthetics, maintaining a sleek and modern look that blends well with any environment. Its lightweight design facilitates mobility, allowing users to easily relocate the speaker as needed.

In conclusion, the TOA Electronics VFST-CMN-2 is a powerful and resilient speaker system that delivers exceptional performance across different settings. With its durable construction, superior audio quality, and user-friendly features, it stands out as a premier solution for any public address or sound reinforcement needs. Whether used in an educational institution, commercial space, or at an outdoor event, the VFST-CMN-2 ensures clear communication and an outstanding listening experience.