NOTE: You must insert the batteries into the second sensor within 30 seconds of reception of the first sensor.
7.The outdoor temperature from the second sensor and the "channel 3" icon should then be displayed on the Weather station. If this does not happen after 2 minute, the batteries will need
to be removed from all the units and reset from step 1.
Note: only the readings from the internal sensor of the second sensor will be displayed in “channel 3”
IMPORTANT: Transmission problems will arise if the setting for additional sensors is not followed as described above. Should transmission problems occur, it is necessary to remove the batteries from all units and start again the
B. VIEWING AND OPERATING WITH MULTIPLE TEMPERATURE SENSOR UNITS
1.To view the temperature of a different remote temperature sensor unit, press and release the SET/CH button. A shift from one “boxed” number to the next should be observed in the
OUTDOOR LCD.
2.To determine which remote temperature sensor reading is displayed on the 3 channels, match the temperature displayed on each channel, with the corresponding temperature displayed on the LCD of each remote temperature sensor.
3.To view the Minimum/Maximum temperature: first select which remote temperature sensor to read data from (indicated by the “boxed” number), then press the SET/CH button. Pressing this button once will display the minimum temperature, and the date and time the data was recorded.
Pressing this button a second time (while “MIN” is still displayed, otherwise press the button twice) will display the same data for the maximum recordings.
4.To reset the Minimum/Maximum readings, press and hold the MIN/MAX/+ button for 5 seconds, this will reset all the minimum and maximum data from all sensors.
MOUNTING
THE REMOTE TEMPERATURE SENSOR
1.Remove the mounting bracket/stand from the temperature sensor.
2.Place the mounting bracket over the desired location.
3.The mounting bracket can attach to the sensor in the middle of the back or on the bottom.
4.Through the 3 screw holes of the bracket, mark the mounting surface with a pencil.
5.Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket.
6.Insert the remote temperature sensor into the bracket.
Back middle of sensor inserted into Mounting Bracket
Bottom of sensor inserted into Mounting Bracket
8