Kramer Electronics fc-42 user manual Connecting the FC-42

Page 11

5 Connecting the FC-42

i

Always switch off the power to each device before connecting it to your

 

 

FC-42. After connecting your FC-42, connect its power and then switch

 

on the power to each device.

To connect the FC-42, as illustrated in the example in Figure 3, do the following:

1.Connect a component video source (for example, an HDTV Satellite receiver source) to the Y, PB, PR INPUT BNC connectors.

2.Connect the OUTPUTS:

Connect the SDI BNC connector to an HD-SDI acceptor (for example, a non-linear editor)

Connect the SDI BNC connector to an HD-SDI acceptor (for example, an HD-SDI display)

Connect the RGB/HV 15-pin HD computer graphics video connector to an RGBHV acceptor (for example, a projector)

3.Connect a PC or other controller, if required (see Section 5‎ .1).

4.Connect the power cord (not shown in Figure 3).

8

FC-42 - Connecting the FC-42

 

 

Page 10 Page 12
Image 11
Page 10 Page 12
Contents FC-42 Page Figures Introduction Achieving the Best Performance Getting StartedSafety Instructions Recycling Kramer Products Defining the FC-42 Component to HD-SDI Converter OverviewFC-42 Overview FC-42 OverviewBNC Connector Installing in a Rack Connecting the FC-42 Connecting the FC-42 Component to HD-SDI Converter Crossed Cable RS-232 Connection Connecting to the FC-42 via RS-232Operating the FC-42 HD-SDI to Component Converter Using the FC-42 Component To HD-SDI ConverterLocking the Front Panel Menu Item Submenu Select SET … Standard AUTO, Forced Select ModeTechnical Specifications Instruction Byte Communication ProtocolLocal Parameter Number Local Parameter Data Description Following table defines the local parameter dataGlobal Parameter Number Global Parameter Data Description Following table defines the global parameter dataPage Safety Warning
Top Page Image Contents