Guardian Technologies R3010 Power Button, Warm or Cool Mist Button, Program Start, Program Stop

1.Power Button

Before turning on make sure there is water in the unit. Press the Power Button.

P ower

The programmable mode allows you to set the timer to turn the humidifier both on/off at a daily predetermined time. This mode also allows the clock to be programmed.

FIRST TURN POWER BUTTON ON.

S tart

S top

Done set

r

S p

C

2.Warm or Cool Mist Button

Press to select warm or cool mist. Water

temperature is maintained at room temperature for cool setting and 80 degrees for warm.

Select/Set

Time

Hour

Minute

Cool/W arm

Program Start

1.	Push Select/Set Button until "START" is blinking on display.
2.	While "START" is blinking, select the desired start time using Hour and
	Minute buttons (AM or PM as indicated).

Dim

Spray

Control

3.Spray Control Button

When you press the Spray Control Button there are four options to choose from:

Press once for WEAK

Press twice for MIDDLE

Press three times for STRONG

Press four times for TURBO

*You will notice the lights get higher as the spray increases.

3.	Select Cool/Warm preference.
4.	Select Spray Control preference.
5.	"START" indicator will remain lit once programmed.

Program Stop

1.	Push Select/Set Button until "STOP" is blinking on display.
2.	While "STOP" is blinking, select the desired end time using Hour and
	Minute buttons (AM or PM as indicated).
3.	"STOP" indicator will remain lit once programmed.

4A. Light Options - Display Button

Press the Display Button to turn the display lights ON or OFF.

Display

4B. Light Options - Night Light Feature

Press the Lamp Button at the top of the unit to illuminate the night light feature.

Lamp

5.Water Refill Button

When the Water Refill Button lights up it is time to refill the water tank.

4. To cancel program, press and hold select/set button for two seconds

(START and STOP buttons will not be lit).

Clock Set

1.Clock must be set in order for timer to work properly.

2.Push Select/Set Button until "TIME" is blinking on display.

3.Select actual time using Hour and Minute Buttons (AM or PM as indicated).

E-6 E-7