Icom I706MKTMG Programmed scan operation, Memory scan operation, Select memory scan operation

MEMORY AND SCAN OPERATION 5

■Programmed scan operation

➀Select VFO mode.

➁Select the desired operating mode.

•The operating mode can also be changed while scan- ning.

➂Set [SQL] open or closed.

•See page a left for squelch condition.

➃Select S2, then push [(F-1)SCN] to start the scan.

USB

S1 3 5 7 9	20 40	60dB	VFO A		Select
					VFO mode
PO	5	10		CH

S2 SCN PRI V/M

•Decimal point blinks while scanning.

➄When the scan detects a signal, the scan turns OFF, pauses or ignores it depending on the resume setting and the squelch condition.

•During scan [TS] can be used only when resume is ON.

➅To cancel the scan push [(F-1)SCN].

F-1 then push [(F-1)SCN]

Note: If the same frequencies are programmed into the scan edge memory channels 1A and 1B, pro- grammed scan does not start.

■Memory scan operation

➀Select memory mode.

➁Close the squelch with [SQL].

➂Select S2, then push [(F-1)SCN] to start the scan.

•Decimal point blinks while scanning.

➃When the scan detects a signal, the scan stops or pauses depending on the resume setting.

➄To cancel the scan push [(F-1)SCN].

USB

S1	3	5	7	9	20	40	60dB	Select
								memory mode
PO					5		10 MEMO CH
S2 SCN SEL V/M

F-1 then push [(F-1)SCN]

Note: Two or more memory channels must be pro- grammed for memory scan to start.

■Select memory scan operation

➀Select memory mode.

➁Close the squelch with [SQL].

➂Select S2, then push [(F-1)SCN] to start the mem-

ory scan.

•Decimal point blinks while scanning.

➃Push [(F-2)SEL] to change the memory scan to select memory scan.

•Push [(F-2)SEL] for 2 sec. to clear all select memory channels.

➄When the scan detects a signal, the scan stops or pauses depending on the resume setting.

➅To cancel the scan push [(F-1)SCN].

			USB						Select
									memory mode
S1	3	5	7	9	20	40	60dB	S	Designate
							10 MEMO
PO					5			CH

S2 SCN SEL V/M “S.”

F-1 F-2

Push [(F-1)SCN], then [(F-2)SEL].

Note: Two or more memory channels must be desig- nated as select memory channels for select memory scan to start.

■Priority watch

➀Select VFO mode, then set a frequency.

➁Close the squelch with [SQL].

➂Set the desired memory channel as the watching

channel.

➃Select S2, then push [(F-2)PRI] to start the watch.

•Decimal point blinks while scanning.

➄When the scan detects a signal, the scan pauses for 10 sec. or until the signal disappears, depend- ing on the resume setting.

➅To cancel the scan push [(F-2)PRI].

USB

				Select
				VFO mode
S1 3 5 7 9	20 40	60dB	VFO A
PO	5	10	CH	Select watching

S2 SCN PRI V/M		channel
F-2	Push [(F-2)PRI].

Note: The paused condition when detecting a signal differs depending on the scan resume condition. resume on: pauses for 10 sec.

resume off: pauses until the signal disappears.

44