Kenmore 153.335962 Installation Instructions, Locating the New Water Heater, Or Property Damage

Installation Instructions

Locating the New Water Heater

You should carefully choose an indoor location for the new water heater, because the placement is a very important consideration for the safety of the occupants in the building and for the most economical use of the appliance. This water heater is not for use in mobile homes or outdoor installation.

Whether replacing an old water heater or putting the water

heater in a new location, the following critical points must be observed.

1.The location selected sbould be indoors as close as practical

to the vent ternfination point, and as centralized with the water piping system as possible. The water heater, as a[l water heaters, will eventually leak. Do not install without adequate drainage provisions where water flow will cause damage.

2.The vent piping cannot exceed a total of 35 feet inchlding vertical and horizontal runs and have no more than 3 elbows.

it cannot slope downward and horizontal runs require/" per

foot rise. All horizontal runs require adequate support at 3½ feet intervals.

3.The water heater requires its own (separate) venting system. It cannot be connected to an existing vent pipe or chimney.

It must terminate horizontally to the outdoors. Whenever possible terminate the vent on the leaward side of the build-

ing. NOTE: Condensation may be created, at times, as the

combustion gases exit the vent cap and discoloration of

surfaces in proximity to the vent cap may occur.

_IWARNING

The power vent water heater requires itsown (separate) venting system. It cannot be connected to an existing vent pipe or chim- ney. It must be terminated horizontally to the outdoors. Failureto properly installthe venting systemcan result in asphyxiation,a fire

or explosion and can causeDEATH, SERIOUS BODILY INJUR_,

OR PROPERTY DAMAGE.

4.The water beater comes equipped with a 5 foot power cord

which can be used to connect to a 110/120 volt power source if(l) local codes allow, and (2) there is a three prong receptacle available.

5.The location selection must provide adequate clearances for servicing and proper operation of the water heater.

IIWARNING

INSTALLATIONS IN AREAS WHERE FLAMMABLE LIQUIDS 'VAPORS) ARE LIKELY TO BE PRESENT OR STORED 'GARAGES, STORAGE, AND UTILITY AREAS, ETC): klammable liquids (such as gasoline, solvents, propane (LP) or

butane, etc.), all of which emit flammable vapors, may be improperly stored or used in suchareas. The gas water heater

pilot light or main burner can ignite such vapors. The resulting flashbackand fire can cause death or serious bums to anyone m the area, as well as property damage.

If installation in such areas is your only option, then the installa. tion must be accomplished in a way that the pilot flame and main burner flame are elevated from the floor at least 18 inches.

While this may reduce the chancesof flammable vapors from a floor spill being ignited,gasolineand other flammable substances shouldnever be stored or used in the same room or area con-

raining a gas water heater or other open flame or spark produc-

ing appliance.

NOTE: Flammable vapors may be drawn by air currents from other areas of the structure to the appliance.

•_ WARNING

Propell_nts of aerosol sprays and volatile compounds, (clean- ers, chlorine based chemicals, refrigerants, etc.) in addition to being highly flammable in many cases,will also change to cor- rosive hydrochloric acid when exposed to the combustion products of the water heater. The results can be hazardous, and also cause product failure.

AWARNING

This water heater must not be installed directly on carpeting.

Carpeting must be protected by a metal or wood panel beneath the appliance extending beyond the full width and depth of the appliance by at least 3 inches (76.2mm) in any direction, or if the appliance is installed in an alcove or closet, the entire floor must be covered by the panel. Failure to heed this warning may result in a fire hazard.

IIWARNING

Do not useanextensioncord. If there isnot a suitablerecepta. I tie and/orlocalcodesprohibituseof a powercord,field wiring

must be provded.

ACAUTION

WATER HEATERS EVENTUALLY LEAK: Installation of the water heater must be accomplished in such a manner that if the tank or any connections should leak, the flow of water will not cause damage to the structure. When such locations cannot be avoided, a suitable drain pan should be installed under the water heater. Drain pans are available at your local Sears store. Such a drain pan must be not greater than 1½ inches deep, have a minimum length and width of at least 2 inches greater than the water heater dimensions and must

be piped to an adequate drain. The pan must not restrict combustion air flow. Under no circumstances is the manu-

facturer or Sears to be held liable for any water damage in connection with this water heater.

AWARNING

Minimum clearances between the water heater and com- bustible construction are 0" at the sides and rear, 5" at the front, and fl" from the vent pipe. Clearance from the top of the

jacket is 14"on most models. Note that a lesserdimension may be allowed on some models. Refer to the label on the water

heater adjacent to the gas control valve for all clearances.

J2"_	_IIN		I)" MIN
	VEN TILATION
	AIR
	OPENINGS
	TOP VIEW II" MIN _
	OF CLOSET	10P	VIEW
	WITHOUT DOOR	OF CLOSET
	_' MAX.	Wl]H	DOOR

Figure I ] AlE DUCT