Kenmore 153.337762, 153.33796 Installation Instructions contd, Facts to Consider About Location

Page 9

Installation Instructions (cont'd)

Facts to Consider About the

Location

You should carefully choose an indoor location for the new

water heater, because the placement is a very important consid- eration for the safety of the occupants in the building and for the most economical use of the appliance. This water heater is not for use in mobile homes or outdoor installation.

Whether replacing an old water heater or putting the water

heater in a new location, the following critical points must be observed.

The location selected should be indoors as close as practical to the gas vent or chimney to which the water heater vent is going to be connected, and as centralized with the water pip-

in._ system as possible. The water heater, as all water heaters will eventually leak. Do not install without adequate

drainage provisions where water flow will cause damage.

&CAUTION

WATER HEATERS EVENTUALLY LEAK: Installation of the

water heater must be accomplisbedin sucha manner that if the tank or any connectionsshouldleak, the flow of water will not causedan_ge to the structure. Wben suchIocatfonscan- not be avoided, a soitalde drain pan should be installedunder the water buater. Drain pansm_eavailableat your local Sears store. Such a drain pan must be lootgreater than I _ inches deep, have a minimum length and width of at least 2 inches

greater than the water heater dimensionsand must be piped i to an adequatedrain.The panmust not restrict combustionair

i Bow.Under no circumstancesis the manufacturer or Sears to

!be held liable for any water damage in connection with this

!water heater.

The location selection must provide adequate clearances for ser- vicing and proper operation of the waterheater.

AWARNING

This water heater must loot be installeddin_y on carpeting.

Carpeting must be protected by a metal or wood panel beneath the appliance extending beyond the full width and depth of the appliance by at least 3 inches (76.2mm) in any direction, or if the applianceis installedin an alcoveor deset, the entire floor must be coveredby the panel. Failure to heed this warningmay resultin a fire hazard.

AWARNING

Minimum clearances between the water heater and com- bustible construction are I" at the sidesand rear, 4" at the front, and 6" frem the vant pipe.Clearancefrom the top of the jacketis I8" on most modelg Note that a lesserdimensionmay be allowed on some modelg Refer to the labelon the water heater adjacantto the gascnotrel vaive for all dearance_

12"M__

VENTILATION

TOP V_E'V,/

 

OF CLOSET

TOP VI_

WITHOUT DOOR

V_OIFT_d_

AWARNING

Figure I ]

AIR DUCT

INSTALLATIONS IN AREAS WHERE FLAMMABLE LIQUIDS VAPORS) ARE LIKELY TO BE PRESENT OR STORED

GARAGES, STORAGE, AND UTILITY AREAS ETC): qammable iquids(suchasgasoline,solvents,propane(LP) or butane, etc.), all of which emit flammable vapors, may be improperlystored or usedin suchare_ The gaswater heater _ot light or main burner camignitesuch vaporL The resul_ng flashbackand fire can causedeath or seriousbumsto anyonein the area,eswell m pmporty damage.

If installat_n in suchareasis youronly option,then the installa-

tion must be accomplishedin a way that the pilot flame and main bureor flame are eleva_._freml the goor at least 18inches.

While this may reducethe chancesof flammablevaporsfrom a floor spillbeingigeited, gasolineand other flammablesubstances shouldneverbe stored or usedin the same room or area con.

talninga gaswater heater or other open flame or sparkproduc. ingappliance.

NOTE: Flammable vaporsmay be drawn by air currentsfrom

other areasof the structureto the appliance.

AWARNING

Propellantsof aerosol spraysand vohLtilecompounds,(clean- er_ chlorine based chemicals,rofrigeran_, etc.) in addition to beinghighlyflammable in many cases,will also changeto cor- rosive hydrochloric acid when exposed to the combustion products of the wator beator. The resultscan be hazardous, and also causeproduct failure.

AWARNING

Ages wat_ bea_r cannot aperato preperly without the co_ rect amount of air for combustler_Do not installin a confined area sucha closet,unle_ you provideair as shownin Figures I-5. Never obstruct _ flow of ventilation air. If you have any doubtsor questionsat all, callyour gascompany.Failureto pro- vide the proper amount of combustionair canresult in a Ere or explosionand can cause DEATH, SERIOUS BODILY INJUI_,

OR PROPERTYDAMAGE.

AWARNING

If this water heater will be usedin beauty shops,barber shops, cleaning establishments, or self-service laundries with dry cleaningequipment, it is imperative that the water heater or water heaters be installed sothat combustionand ventilation air be taken from outsidethese areas, Refer to the "Facts to ConsiderAbout the Location" sectionof this manual and also the latest edition of the National Fuel Gas Code, ANSI 7.223.1, also referred to as NFPA 54 for specificsprovidedconcerning air e_luired.

9

Image 9
Contents Not for USE For Your SafetyAN Odorant is Added to the GAS Used by this Water Heater What to do if YOU Smell GASInstallations in Areas Where Flammable LIQ Safety PrecautionsHotter Water can Scald Water heaters are Safety PrecautionsImproper operation, explosionor asphyxiation ExVemelyflmmae d mqse. To preventthe pemContents Customer Responsibilities Product Specifications59½ 58¼Materials and Basic Tools Needed Materials NeededBasic Tools Removing the Old Water Heater Installation InstructionsIf the main gasline--all Gasappliancesis Used, lso shut doffthe gasat eachappliance LeaveallInstallation Instructions contd Water Heaters Eventually Leak InstallationFacts to Consider About Location Installation Instructions contd ALL AIR from Inside BuildingsALL AIR from Outdoors seeFigures3-5 HOVrERWATERCAN SCALDWater. heatersareintendedto Water PipingDischargePipe At the time of manufacture this water heater was providedVenting Filling the Water HeaterHeaithriskor Sionor asphyxonGas Piping Use pipejoint compoundor teflon tape marked as beingJ GAS Piping with Flexible ConnectorSediment Trap ContaminentsInthe Ips rmesn/came OperonInstallation Checklist Operating Instructions LightingCheck for Leaks Whattodoif Yousmellgas Operating Instructions contdNot Force ForceOperating Instructions contd Temperature RegulationSonunattendedn a bathtubor shower Hotter Water can Scald Water heatersare intendedtoTank Sediment Cleaning Service and AdjustmentBurner Cleaning Burner InspectionGas Control Valve & Burner Assembly Replacement Information Service and Adjustment contdWhan chedd the tempereteretammrer vae opera Pmper dame beaue thewaternW beexm.y hotFollow instructions in the Filling The Water Heater section HousekeepingStart Up Conditions Troubleshooting GuideThermal Expansion Strange SoundsCondensationsmokeiodor Start Up Conditions contdSmelly Water AIR in HOT Water FaucetsHigh Temperature Shut OFF System Troubleshooting Guide contdNot Enough or no HOT Water Water is TOO HOTNever use this water ter Leakage CheckpointsPage Page Page Parts Order List Power Miser TM 9 GAS Water Heaters Model NumbersParts Order List contd Model Ratin PlatetChick Power Miser TM 9 GAS Water Heaters Model Number Parts Order List contd Manual KEYEm-4ee4ees Lightingpilot Leaksinpipesorfittings

153.337113, 153.337462, 153.337513, 153.337762, 153.337413 specifications

The Kenmore series 153.337662, 153.337562, 153.337462, 153.337113, and 153.33796 represents a range of high-performance appliances that deliver exceptional functionality and convenience to homeowners. Renowned for their energy efficiency and advanced technologies, these models are designed to cater to various household needs while maintaining a focus on user-friendly operation.

One of the hallmark features of the Kenmore 153 series is its innovative Smart Technology. This technology enables users to connect their appliances to a home network, allowing for remote control and monitoring through smartphone apps. With this capability, users can adjust settings, receive alerts, and even troubleshoot issues from virtually anywhere, providing enhanced convenience and peace of mind.

In addition to Smart Technology, the Kenmore 153 series is equipped with advanced sensors that optimize performance. For example, the models feature moisture sensing capabilities that detect the dampness of clothes and automatically adjust drying time accordingly. This not only saves energy but also protects fabrics from over-drying, thus extending the life of garments.

Energy efficiency is another critical characteristic of the Kenmore 153 series. These appliances are designed with eco-friendly functionalities that minimize energy consumption without compromising performance. They often come with Energy Star certification, allowing users to enjoy significant savings on utility bills while contributing to a more sustainable environment.

The Kenmore 153 series also boasts a sleek and modern design that integrates seamlessly into any home decor. With user-friendly control panels, bright displays, and customizable settings, these appliances are as functional as they are aesthetically pleasing. Whether it's a refrigerator, washing machine, or dryer, each model is built with durability in mind, ensuring they withstand the rigors of daily use.

Furthermore, the Kenmore 153 series emphasizes easy maintenance and cleaning. Many models feature self-cleaning options and removable components that simplify the upkeep process, allowing users to spend less time on chores and more time enjoying their homes.

In summary, the Kenmore 153.337662, 153.337562, 153.337462, 153.337113, and 153.33796 models exemplify a commitment to quality, efficiency, and innovative technology. With features that enhance usability and performance, these appliances stand out in the marketplace, making them a popular choice for modern households looking to elevate their everyday living experiences.