Kenmore 153.330632, 153.330652 Insulation Blankets, Breathing Hazard Carbon Monoxide Gas

Page 10

 

Fire or Explosion

Hazard

 

using or servicing water heater.

 

• Improper use may result in fire or

Read

explosion.

before installing,

instruction manual

• Maintain required clearances to combustibles.

Minimum clearances between the water heater and combustible surfaces are 0 inch at the sides and rear, 4 inches (102 mm) at the front, and 6 inches (153 mm) from the vent pipe, see Figure 8. Clearance from the top of the jacket is 8 inches (203

mm)on most models. Note that a lesser dimension may be allowed on some models, refer to the label attached adjacent to the gas control valve on the water heater.

TOP VIEW

TOP VIEW

 

OF CLOSET

OF CLOSET

 

WITHOUT DOOR

WITH DOOR

 

0" MIN.

0"

MIN.

 

4"

IV]IN.

 

(104

ram)

 

0" MIN.

 

FIGURE

8.

 

12" MAX. (30 cm)

3" MIN.

76,2 mm

AIR DUCT

FRONT VIEW _"

OF DOOR

FIGURE 9.

If this water heater wilt be used in beauty shops, barber shops, cleaning establishments, or self-service laundries with dry cleaning equipment, it is imperative that the water heater or water heaters be installed so that combustion and ventilation air be taken directly from outdoors (direct vent).

Propellants of aerosol sprays and volatile compounds, (cleaners, chlorine based chemicals, refrigerants, etc.) in addition to being highly flammable in many cases, wilt also change to corrosive hydrochloric acid when exposed to the combustion products of the water heater. The results can be hazardous, and also cause product failure.

Insulation Blankets

Insulation blankets available to the general public for external use on gas water heaters are not necessary with Kenmore products. The purpose of an insulation blanket is to reduce the standby heat toss encountered with storage tank heaters. Your Kenmore water heater meets or exceeds the National Appliance Energy Conservation Act standards with respect to insulation and standby loss requirements, making an insulation blanket unnecessary.

Breathing Hazard - Carbon Monoxide Gas

Install water heater in accordance with the instruction manual and NFPA 54.

To avoid injury, combustion and ventilation air must be taken from

outdoors.

Do not place chemical vapor

emitting products near water heater.

Breathing carbon monoxide can cause brain damage or death. Always read and understand instruction manual.

A gas water heater cannot operate properly without the correct amount of air for combustion, see Figure 9. Do not install in a confined area such as a closet, unless you provide air as shown in the Locating The New Water Heater section. Never obstruct the flow of ventilation air. If you have any doubts or questions at all, call your gas supplier. Failure to provide the proper amount of combustion air can result in a fire or explosion and cause death, serious bodily injury, or property damage.

Breathing Hazard - Carbon Monoxide Gas

 

",_°'..'.;:

intake with insulating blanket.

__!il

Do not obstruct water heater air

 

"::':;_':: •

Gas and carbon monoxide detectors

__

areInstallava,tablewater. heater in accordance

_.i'_

 

with the instruction manual.

 

I

 

Breathing carbon monoxide can cause brain damage or death. Always read and understand instruction manual.

'_ WARNING

Should you choose to apply an insulation blanket to this heater, you should follow these instructions (See Figure 1 for identification of components mentioned below). Failure to follow these instructions can restrict the air flow required for proper combustion, potentially resulting in fire, asphyxiation, serious personal injury or death.

Do not apply insulation to the top of the water heater, as this wilt interfere with safe operation of the draft hood.

Do not cover the outer door, thermostat or temperature & pressure relief valve.

Do not allow insulation to come within 2" (50.8 mm) of the floor to prevent blockage of combustion air flow to the burner.

Do not cover the instruction manual. Keep it on the side of the water heater or nearby for future reference.

10

Image 10
Contents Gallon Gallon ShortImportant Definitions Fire Hazard Improper installation and use may result Property damageFire or Explosion Hazard Explosion HazardBurner Door Assembly Ultra Low NOx Natural Gas Burner Temperature Pressure Relief Valve 13-14 Filling the WaterTemperature Regulation Burner Door Assembly Piezoelectric90F Rise Jacket TOP Materials Needed Additional Tools Needed When Sweat SolderingBasic Tools GET to Know Your Water Heater GAS Models Pilot & Main BurnerRemoving the Old Water Heater Facts to Consider About Location Property Damage HazardInsulation Blankets Breathing Hazard Carbon Monoxide GasALL AIR from Inside Buildings Water Piping Hotter Water can ScaldInstallation Completed Using KIT Property Damage HazardExplosion Hazard Water Damage HazardFilling the Water Heater VentingGas Piping Fire and Explosion HazardSediment Traps Fire and Explosion HazardFor g Besuretosmellnextto thefor cause some EplacementoftheentirewaterheaterBEFORELiGHTiNGsmellaNiaroundtheapplian area Gasisheavithanair andlNsoftieonthefiordTemperature Regulation Burner Inspection Tank Sediment CleaningCarbon Monoxide and Fire Hard Vent System InspectionRemoving the Burner Door Assembly Ultra Low NOx Natural Gas BurnerCleaning the Combustion Chamber and Flame Arrestor External Inspection & Cleaning of the Flame ArrestorReplacing the Thermocouple Replacing the Burner Door Assembly Fire or Explosion Hazard Explosion HazardFire and Explosion Hazard Removing and Replacing the Gas Control Valve/ThermostatHousekeeping Anode Rod InspectionService Temperature-Pressure Relief Valve OperationDrain Valve Washer Replacement DrainingStrange Sounds Expansion Tank Sizing ChartStart Up Conditions Draft Hood OperationSmoke Odor CondensationAIR In Hot Water Faucets Slow HOT Water Recovery Insufficient HOT WaterShut OFF Drip from Relief ValveThermostat Fails to Combustion OdorsSection a Pilot light will not light Ivalve/thermstat?Power Miser TM 6 GAS Water Heater Year Limited Warranty on Water Heater Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A

153.330642, 153.33062, 153.330632, 153.330652 specifications

The Kenmore model series 153.330632, 153.330652, 153.33062, and 153.330642 represent a versatile lineup of washing machines designed to cater to a variety of laundry needs. Each model comes equipped with unique features and technologies aimed at enhancing the user's washing experience while ensuring reliability and performance.

One of the standout features across these models is their efficient water usage. Designed with modern technology, these machines incorporate advanced sensors that adjust the water level according to the load size. This not only conserves water but also contributes to lower utility bills, making them environmentally friendly options.

In terms of operation, the Kenmore models boast a range of wash cycles tailored to different fabric types and soil levels. From delicate items to heavy-duty fabrics, users can choose the appropriate cycle to ensure optimal cleaning without damaging their garments. The presence of a quick wash option is also a highlight, enabling users to clean lightly soiled items in a fraction of the time.

The Kenmore series is also designed for user convenience. Features such as a digital display control panel allow for intuitive operation. Users can easily select their desired settings and monitor the wash cycle progress. Additionally, the machines are equipped with a delay start function, which provides flexibility for users to schedule their laundry according to their convenience.

Another notable characteristic of these models is the installation of noise-reducing technologies. This minimizes operational sounds, allowing for quieter washing cycles, which is particularly beneficial for households with infants or those who prefer a tranquil environment.

Durability is a significant aspect of the Kenmore brand. Each machine in this series is constructed with high-quality materials designed to withstand the rigors of regular use. The stainless-steel tubs are resistant to chipping and snagging, ensuring that they maintain their efficiency over long periods.

In summary, the Kenmore models 153.330632, 153.330652, 153.33062, and 153.330642 are packed with features aimed at improving the laundry experience. With efficient water usage, versatile wash cycles, user-friendly controls, noise reduction technologies, and durable construction, these machines stand out as reliable choices for modern households seeking an effective laundry solution. As users navigate their laundry tasks, these washing machines promise to deliver performance while keeping convenience and sustainability at the forefront.