Kenmore 153.330652, 153.33062, 153.330632, 153.330642 Water Piping, Hotter Water can Scald

Page 12

GAS VENT

Water Piping

INLET AIR DUCT

FIGURE 13.

Alternatively a single permanent opening may be used when communicating directly with the outdoors, or with spaces that freely communicate with the outdoors. The opening shall have a minimum free area of 1 square inch per 3,000 BTU per hour (8.3 cm2/kW) of total input rating of all equipment in the enclosure. See Figure 13A.

OR

GAS VENT

OPENING

LOCATION

FIGURE 13A.

Louvers and Grilles: In calculating free area, consideration shall be given to the blocking effect of louvers, grilles or screens protecting openings. Screens used shall not be smalter than 1/4 inch (6.4 mm) mesh. If the free area through a design of louver or grille is known, it should be used in calculating the size opening required to provide the free area specified. If the design and free area is not known, it may be assumed that wood louvers wilt be 20-25 percent free area and metal louvers and grilles wilt have 60-75 percent free area. Louvers and grilles shall be fixed in the open position or interlocked with the equipment so that they are opened automatically during equipment operation.

Special Conditions Created by Mechanical Exhausting or Fireplaces: operation of exhaust fans, ventilation systems, clothes dryers or fireplaces may create conditions requiring special attention to avoid unsatisfactory operation of installed gas utilization equipment.

 

Water temperature

over 125°F

 

(52°C) can cause severe burns

 

instantly resulting in severe injury

 

or death.

 

 

 

 

,)

physically

or mentally

disabled

_)(_

a re at highest riskfor scald injury.

Children,

elderly,

 

and

the

_._

Feel water before bathing or

_.

Temperature

limiting

 

valves

are

 

available.

 

 

 

 

 

Read instruction manual for safe

.

tern perature

setting,

 

 

 

HOTTER WATER CAN SCALD:

Water heaters are intended to produce hot water. Water heated to a temperature which will satisfy space heating, clothes washing, dish washing, cleaning and other sanitizing needs can scald and permanently injure you upon contact. Some people are more likely to be permanently injured by hot water than others. These include the elderly, children, the infirm, or physically/mentally handicapped. If anyone using hot water in your home fits into one of these groups or if there is a local code or state law requiring a certain temperature water at the hot water tap, then you must take special precautions.

In addition to using the lowest possible temperature setting that satisfies your hot water needs, a means such as a *mixing valve should be used at the hot water taps used by these people or at the water heater. Mixing valves are available at plumbing supply or hardware stores. See Figure 14. Valves for reducing point of use temperature by mixing cold and hot water are also available. Follow manufacturer's instructions for installation of the valves. Before changing the factory setting on the thermostat, read the Temperature Regulation section in this manual.

 

HOoTuWATER

 

COLD

WATER

 

 

 

 

 

TLET

_

 

 

TEMPERED

_]]__J

 

 

 

WATEROUTLET_.T_L.[_,_

_

 

 

+-

+

TO COLD

WATER

 

 

 

INLET ON

 

*NIXING

HOT WATER

WATER

HEATER

 

 

 

 

VALVE

OUTLET ON

 

 

 

 

WATER HEATER

 

 

FIGURE 14.

Toxic Chemical Hazard

• Do not connect to non-potable water system.

12

Image 12
Contents Gallon Gallon ShortImportant Definitions Improper installation and use may result Property damage Fire or Explosion HazardFire Hazard Explosion HazardTemperature Pressure Relief Valve 13-14 Filling the Water Temperature RegulationBurner Door Assembly Ultra Low NOx Natural Gas Burner Burner Door Assembly Piezoelectric90F Rise Jacket TOP Additional Tools Needed When Sweat Soldering Materials NeededBasic Tools GET to Know Your Water Heater GAS Models Pilot & Main BurnerRemoving the Old Water Heater Facts to Consider About Location Property Damage HazardInsulation Blankets Breathing Hazard Carbon Monoxide GasALL AIR from Inside Buildings Water Piping Hotter Water can ScaldInstallation Completed Using KIT Property Damage HazardExplosion Hazard Water Damage HazardFilling the Water Heater VentingGas Piping Fire and Explosion HazardSediment Traps Fire and Explosion HazardEplacementoftheentirewaterheater BEFORELiGHTiNGsmellaNiaroundtheapplian areaFor g Besuretosmellnextto thefor cause some Gasisheavithanair andlNsoftieonthefiordTemperature Regulation Tank Sediment Cleaning Carbon Monoxide and Fire HardBurner Inspection Vent System InspectionRemoving the Burner Door Assembly Ultra Low NOx Natural Gas BurnerExternal Inspection & Cleaning of the Flame Arrestor Cleaning the Combustion Chamber and Flame ArrestorReplacing the Thermocouple Replacing the Burner Door Assembly Fire or Explosion Hazard Explosion HazardRemoving and Replacing the Gas Control Valve/Thermostat HousekeepingFire and Explosion Hazard Anode Rod InspectionTemperature-Pressure Relief Valve Operation Drain Valve Washer ReplacementService DrainingExpansion Tank Sizing Chart Start Up ConditionsStrange Sounds Draft Hood OperationCondensation Smoke OdorAIR In Hot Water Faucets Slow HOT Water Recovery Insufficient HOT WaterDrip from Relief Valve Thermostat Fails toShut OFF Combustion OdorsSection a Pilot light will not light Ivalve/thermstat?Power Miser TM 6 GAS Water Heater Year Limited Warranty on Water Heater Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A

153.330642, 153.33062, 153.330632, 153.330652 specifications

The Kenmore model series 153.330632, 153.330652, 153.33062, and 153.330642 represent a versatile lineup of washing machines designed to cater to a variety of laundry needs. Each model comes equipped with unique features and technologies aimed at enhancing the user's washing experience while ensuring reliability and performance.

One of the standout features across these models is their efficient water usage. Designed with modern technology, these machines incorporate advanced sensors that adjust the water level according to the load size. This not only conserves water but also contributes to lower utility bills, making them environmentally friendly options.

In terms of operation, the Kenmore models boast a range of wash cycles tailored to different fabric types and soil levels. From delicate items to heavy-duty fabrics, users can choose the appropriate cycle to ensure optimal cleaning without damaging their garments. The presence of a quick wash option is also a highlight, enabling users to clean lightly soiled items in a fraction of the time.

The Kenmore series is also designed for user convenience. Features such as a digital display control panel allow for intuitive operation. Users can easily select their desired settings and monitor the wash cycle progress. Additionally, the machines are equipped with a delay start function, which provides flexibility for users to schedule their laundry according to their convenience.

Another notable characteristic of these models is the installation of noise-reducing technologies. This minimizes operational sounds, allowing for quieter washing cycles, which is particularly beneficial for households with infants or those who prefer a tranquil environment.

Durability is a significant aspect of the Kenmore brand. Each machine in this series is constructed with high-quality materials designed to withstand the rigors of regular use. The stainless-steel tubs are resistant to chipping and snagging, ensuring that they maintain their efficiency over long periods.

In summary, the Kenmore models 153.330632, 153.330652, 153.33062, and 153.330642 are packed with features aimed at improving the laundry experience. With efficient water usage, versatile wash cycles, user-friendly controls, noise reduction technologies, and durable construction, these machines stand out as reliable choices for modern households seeking an effective laundry solution. As users navigate their laundry tasks, these washing machines promise to deliver performance while keeping convenience and sustainability at the forefront.